Bipolar Plates Injection Molded for Series Production
نویسندگان
چکیده
منابع مشابه
Development of Integrally Molded Bipolar Plates for All-Vanadium Redox Flow Batteries
Chih-Hsun Chang 1, Han-Wen Chou 2, Ning-Yih Hsu 2 and Yong-Song Chen 1,* 1 Advanced Institute of Manufacturing with High-tech Innovations and Department of Mechanical Engineering, National Chung Cheng University, No. 168, University Rd., Minhsiung Township, Chiayi 62102, Taiwan; [email protected] 2 Institute of Nuclear Energy Research, Atomic Energy Council, No. 1000 Wenhua Rd., Jiaan Village...
متن کاملProduction and Analysis of Injection Molded Micro-Optic Components
Injection molding is a manufacturing technique that, through filling of a mold cavity (typically made from steel or aluminum alloys) with molten polymer, produces plastic parts. The geometry of the mold cavity is identical to the desired part shape, after taking into account thermal shrinkage. This manufacturing process is an economical and reliable way to mass-produce a variety of parts. Tradi...
متن کاملBipolar Plates
• good electrical conductivity (>100 S cm 1 bulk conductivity), • high thermal conductivity (>20 W cm ), • high chemical and corrosion resistance, • mechanical stability toward compression forces, • low permeability for hydrogen, • low-cost material being processable with mass production techniques, • low weight and volume, and • recyclable materials. Two different kinds of materials have been ...
متن کاملStudy on Effects of Molded Conditions on the Fiber Orientation and Electrical Conductivity of Injection Molded Bipolar Plate for Fuel Cell
Fuel cells constitute one of the most promising sources of clean energy for the 21 century and bipolar plate is an important component of a PEM fuel cell. Polymers filled with conducting fibers have been chosen as a candidate material for bipolar plates which needs to fulfill the surface conductivity requirement. In the present paper, effect of processing parameters including melt temperature, ...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Research & Development in Material Science
سال: 2020
ISSN: 2576-8840
DOI: 10.31031/rdms.2020.14.000836