Biaxial Constrained Recovery in Shape Memory Alloy Rings
نویسندگان
چکیده
منابع مشابه
Constrained Force Control of Shape Memory Alloy Actuators
Experimental results are presented to show that SMA actuators are able to control forces both rapidly and precisely. An antagonistic pair of constrained actuators is shown to be capable of rapidly changing the setpoint throughout a 7.00 N range. Although the system entered into a limit cycle at the setpoint, the limit cycle magnitude was small. The peak to peak amplitude of the limit cycles was...
متن کاملTransformation-Induced Creep and Creep Recovery of Shape Memory Alloy
If the shape memory alloy is subjected to the subloop loading under the stress-controlled condition, creep and creep recovery can appear based on the martensitic transformation. In the design of shape memory alloy elements, these deformation properties are important since the deflection of shape memory alloy elements can change under constant stress. The conditions for the progress of the marte...
متن کاملAn experimental study of the superelastic effect in a shape-memory Nitinol alloy under biaxial loading
Constitutive laws for shape-memory alloys subjected to multiaxial loading, which are based on direct experimental observations, are generally not available in the literature. Accordingly, in the present work, tension–torsion tests are conducted on thin-walled tubes (thickness/radius ratio of 1:10) of the polycrystalline superelastic/shape-memory alloy Nitinol using various loading/unloading pat...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Intelligent Material Systems and Structures
سال: 2007
ISSN: 1045-389X,1530-8138
DOI: 10.1177/1045389x07082378