Bending Fatigue Strength of Spur Gears in Vacuum
نویسندگان
چکیده
منابع مشابه
Bending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملThe source of Acoustic Emission during meshing of spur gears
Condition monitoring of gears with vibration analysis and Spectrometric Oil Analysis Programs (SOAP) are widely accepted and used in the military aviation industry. Whilst the literature to date has shown the application of the Acoustic Emission (AE) technique to gearbox health monitoring still be in its infancy, there exist opportunities to develop the technique into a complementary diagnostic...
متن کاملInvestigation of Metal Stiffeners in FRP Composite Gears for Increasing Tooth Bending Strength
Gears are an integral and necessary component in our everyday lives. Most of the work performed in plastic and metal but very few works available in combine effect of plastic and metal gears. The main problem while referring plastic gear is the bending strength and in case of metal gear is cost. Hence, the work is performed on metal plastic composite gear to get benefit of both. Here use the co...
متن کاملInfluence of dynamic behaviour on elastohydrodynamic lubrication of spur gears
In this study, the elastohydrodynamic lubrication (EHL) behaviour of high-speed spur gear contacts is investigated under dynamic conditions. A non-linear time-varying vibratory model of spur gear pairs is introduced to predict the instantaneous tooth forces under dynamic conditions within both the linear and non-linear operating regimes. In this model, the periodically time-varying gear mesh st...
متن کاملEfficiency and Temperature of Spray Lubricated Superfinished Spur Gears
Gearboxes are one of the most power dense systems used today, and in certain instances their limiting factor is the ability to evacuate heat from the gear contact. This work analyses the efficiency (i.e. heat generation) and tooth temperature in the three lubricating conditions dip, into mesh spray and out of mesh spray for superfinished gears which are then compared to ground gears. A back-to-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1979
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.45.1254