Bend stiffness of laminate microstructures containing three dissimilar materials
نویسندگان
چکیده
منابع مشابه
Non-Laminate Microstructures in Monoclinic-I Martensite
We study the symmetrised rank-one convex hull of monoclinic-I martensite (a twelve-variant material) in the context of geometrically-linear elasticity. We construct sets of T3s, which are (non-trivial) symmetrised rank-one convex hulls of three-tuples of pairwise incompatible strains. In addition, we construct a fivedimensional continuum of T3s and show that its intersection with the boundary o...
متن کاملFailure Criteria Analysis of Laminate Composite Materials
This paper deals with the development of a numerical simulation methodology for estimating damages in laminate composite materials caused by a low-speed impact. Experimental tests were performed on laminate plates reinforced with woven carbon fibers and epoxy resin. Three thickness plates were evaluated. The impact loads were transversal and punctual. Two lamina failure criteria were evaluated....
متن کاملThe Bend Stiffness of S-DNA
– We formulate and solve a two-state model for the elasticity of nicked, doublestranded DNA that borrows features from both the Worm Like Chain and the Bragg-Zimm model. Our model is computationally simple, and gives an excellent fit to recent experimental data through the entire overstretching transition. The fit gives the first value for the bending stiffness of the overstretched state as abo...
متن کاملCeramic Laminate Veneers: Materials Advances and Selection
Porcelain laminate veneers have been a common treatment strategy in dental clinics. It is a conservative method for treatment of esthetic and functional problems in anterior region of oral cavity. Wide range of dental ceramics is now available on market for fabrication of laminate veneers. Clinician should have enough knowledge regarding the composition and properties of these materials in orde...
متن کاملMicro-Study of Dissimilar Welded Materials
The dissimilar joint between aluminum/titanium alloys (Al 6082 and Ti G2) were successfully achieved by CO2 laser welding with a single pass and without filler material using the overlap joint design. Laser welding parameters ranges combinations were experimentally determined using Taguchi approach with the objective of producing welded joint with acceptable welding profile and high quality of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Mechanics and Materials in Design
سال: 2008
ISSN: 1569-1713,1573-8841
DOI: 10.1007/s10999-008-9093-z