Behavior of Pile Subject to Negative Skin Friction and Axial Load
نویسندگان
چکیده
منابع مشابه
The Influence of Negative Skin Friction on Piles and Pile Groups & Settlement of existing Structures
Negative skin friction occurs when concrete piles are situated in soft soils, consolidating soilmass, etc., resulting in a downward force that increases loading on shaft piles and reduces the bearing capacity of the piles. A new concept based on the shifting rate of piles, and the settlement rate of the surrounding soils has been suggested far the study of negative skin friction. Negative skin ...
متن کاملOn the Solvability of Euler Graphene Beam Subject to Axial Compressive Load
In this paper we formulate the equilibrium equation for a beam made of graphene subjected to some boundary conditions and acted upon by axial compression and nonlinear lateral constrains as a fourth-order nonlinear boundary value problem. We first study the nonlinear eigenvalue problem for buckling analysis of the beam. We show the solvability of the eigenvalue problem as an asymptotic expansio...
متن کاملOptimal design of elastically clamped columns subject to distributed axial load
The optimum designs are given for columns which are elastically clamped at both ends and under concentrated and distributed axial loads. The objective is to maximize the buckling load subject to volume and maximum stress constraints. The results for a minimum area constraint are also obtained for comparison. Under a distributed axial load, the stress constraint leads to different minimum cross-...
متن کاملanalytical solution for buckling of composite sandwich truncated conical shells subject to combined external pressure and axial compression load
abstract: the present study deals with the buckling analysis of the laminated composite truncated conical sandwich shells with flexible core subjected to combined axial compressive load and external pressure. higher order governing equations of the motion are presented for conical composite sandwich shells, where they are derived from the hamilton principle. then, by the use of improved higher-...
متن کاملUltimate Load Capacity and Behavior of Thin-Walled Curved-Steel Square Struts, Subjected to Compressive Load
There have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. One set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. Different lengths of curved struts are fabricated so as to cover a practical ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Soils and Foundations
سال: 2004
ISSN: 0038-0806
DOI: 10.3208/sandf.44.6_17