Austenite grain refinement and superplasticity in niobium microalloyed steel.

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Discussion on the Rate Controlling Process of Coarsening of Niobium Carbonitrides in a Niobium Microalloyed Steel

Austenite grain growth in microalloyed steels is governed by the coarsening of fine precipitates present at grain boundaries below the grain coarsening temperature. Zener model is widely used in metals to describe the pinning effect of second phase particles precipitated in the matrix. In this work it has been discussed whether grain boundary or volume diffusion is the rate controlling process ...

متن کامل

Low temperature superplasticity and thermal stability of a nanostructured low-carbon microalloyed steel

We describe here for the first time the low temperature superplasticity of nanostructured low carbon steel (microalloyed with V, N, Mn, Al, Si, and Ni). Low carbon nanograined/ultrafine-grained (NG/UFG) bulk steel was processed using a combination of cold-rolling and annealing of martensite. The complex microstructure of NG/UFG ferrite and 50-80 nm cementite exhibited high thermal stability at ...

متن کامل

Influence of Boron on Initial Austenite Grain Size and Hot Deformation Behavior of Boron Microalloyed Steels

The initial austenite grain size of boron microalloyed steel with three different amounts of boron (20, 40, and 60 ppm) was investigated under different heating temperatures (1150, 1100, and 1050 °C), and hot compression tests of samples in a wide range of temperature (900–1100 °C) and strain rate (0.1–10 s−1) were conducted. It was found that the initial austenite grain size increases with inc...

متن کامل

MODELLING OF KINETICS OF AUSTENITE-TO-ALLOTRIOMORPHIC FERRITE TRANSFORMATION IN 0.37C–1.45Mn–0.11V MICROALLOYED STEEL

The present paper is concerned to the theoretical and experimental study of the growth kinetics of allotriomorphic ferrite in medium carbon vanadium-titanium microalloyed steel. A theoretical model is presented in this work to calculate the evolution of austenite-to-allotriomorphic ferrite transformation with time at a very wide temperature range. At temperatures above eutectoid temperature, wh...

متن کامل

Metallographic techniques for the determination of the austenite grain size in medium-carbon microalloyed steels

Different techniques have been investigated to seek the best procedure to reveal the prior-austenite grain boundaries in three medium-carbon microalloyed steels. This study has been carried out over a wide range of temperatures (950–1250 C) and it has been found that thermal etching (TE) is the best technique to reveal the prior-austenite grain boundaries in these steels. D 2001 Elsevier Scienc...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Transactions of the Iron and Steel Institute of Japan

سال: 1986

ISSN: 0021-1583,1881-1183

DOI: 10.2355/isijinternational1966.26.315