Attenuation and EMI Frequency Spectrum for Distribution Lines
نویسندگان
چکیده
منابع مشابه
EMI Failure Analysis Techniques: I. Frequency Spectrum Analysis
©2009 IEEE where he was a member of the faculty in the Department of Electrical Engineering for 27 years retiring in 1998. Since 1998 he has been the Sam Nunn Eminent Professor of Aerospace Systems Engineering and a Professor of Electrical and Computer Engineering in the Department of Electrical and Computer Engineering at Mercer University in Macon, GA. He has published numerous papers on the ...
متن کاملEMI Camera LSI (EMcam) with On-Chip Loop Antenna Matrix to Measure EMI Noise Spectrum and Distribution
This paper presents a new type of electromagnetic interference (EMI) measurement system. An EMI Camera LSI (EMcam) with a 12 × 4 on-chip 250 × 50 μm2 loop antenna matrix in 65 nm CMOS is developed. EMcam achieves both the 2D electric scanning and 60 μm-level spatial precision. The down-conversion architecture increases the bandwidth of EMcam and enables the measurement of EMI spectrum up to 3.3...
متن کاملHigh frequency model of EMI filter
The EMI filters are usually used for suppression of electromagnetic conducted interference of range 9 kHz-30 MHz. The efficiency of electromagnetic interference filter is described by attenuation characteristics. The value of attenuation of EMI filter depends on main parameters of filter’s elements and its parasitic parameters. Therefore the high frequency model of electromagnetic interference ...
متن کاملApplication of Single-Frequency Time-Space Filtering Technique for Seismic Ground Roll and Random Noise Attenuation
Time-frequency filtering is an acceptable technique for attenuating noise in 2-D (time-space) and 3-D (time-space-space) reflection seismic data. The common approach for this purpose is transforming each seismic signal from 1-D time domain to a 2-D time-frequency domain and then denoising the signal by a designed filter and finally transforming back the filtered signal to original time domain. ...
متن کاملVariable Frequency Modulation for EMI Suppressing in Power Converter
Switch mode power supply (SMPS) is good selection for power supplies of Unmanned Aerial Vehicle (UAV), which is one of the most important interference sources of UAV. The power switches with their high dv/dt and di/dt switching slopes are the sources of electromagnetic interference (EMI). In this paper, a variable frequency modulation technology of the forward converter of UAV is presented, whi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of King Saud University - Engineering Sciences
سال: 1990
ISSN: 1018-3639
DOI: 10.1016/s1018-3639(18)30525-7