ArF Bi-layer Resist for sub-90nm L/S Fabrication
نویسندگان
چکیده
منابع مشابه
Optimization of Bi-layer Lift-Off Resist Process
Bi-layer lift-off metallization techniques offer significant advantages in resolution, removal, process simplicity, undercut control and yield over conventional single-layer lift-off processes. Because of its ease of application, long shelf life and lower tool cost, the polydimethylglutarimide (PMGI) bi-layer process has become an attractive method for the metallization of III-V compound semico...
متن کاملResist evaluation for Ni mold fabrication and proton beam writing
In our experiments, we use different photoresists for proton beam writing and mold fabrication. We have fabricated Ni mold with structures down to 500 nm. We first use a fine focused proton beam to expose different photoresists, Polymethyl Methacrylate (PMMA), AR-P 3250 and ma-N 2410. After development and nickel sulfamate electroplating, the structures were faithfully transferred from the phot...
متن کاملFabrication and thermoelectric characteristics of [(Bi,Pb)[sub 2]Ba[sub 2]O[sub 4±w]][sub 0.5]CoO[sub 2] bulks with highly aligned grain structure
Rights: © 2008 AIP Publishing. This is the accepted version of the following article: Motohashi, T. & Nonaka, Y. & Sakai, K. & Karppinen, Maarit & Yamauchi, H. 2008. Fabrication and thermoelectric characteristics of [(Bi,Pb)[sub 2]Ba[sub 2]O[sub 4±w]][sub 0.5]CoO[sub 2] bulks with highly aligned grain structure. Journal of Applied Physics. Volume 103, Issue 3. 033705/1-6. ISSN 0021-8979 (printe...
متن کاملMono-Mono-Mono and Bi-Bi-Bi three-layer graphene systems’ optical conductivity
Investigating the longitudinal optical conductivity of graphene systems, which is the mostimportant property for opto-electronic devices, for three-layer graphene systems theoretically and numerically is the main purpose of this study. Each layer can be mono- or bi-layer graphene. Separation between layers has been denoted by d, selected to be about ten nanometers. The carrier densities i...
متن کاملFabrication and Evaluation of Bi-layer Tablet Containing Conventional Paracetamol and Modified Release Diclofenac Sodium
The objectives of present investigation were to achieve immediate release of paracetamol and tailored release of diclofenac sodium from bi-layer tablets. A 2(3) full factorial design was adopted using the amount of polyethylene glycol, microcrystalline cellulose and crospovidone as independent variables for fabricating paracetamol tablets. Diclofenac sodium tablets were prepared using hydroxypr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 2003
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.16.499