Analysis of sheet surface roughness change under contact with flat and spherical indenters
نویسندگان
چکیده
منابع مشابه
Finite element simulation of the effect of surface roughness on nanoindentation of thin films with spherical indenters
The effect of the surface roughness on nanoindentation results was investigated instancing a series of CrN thin films deposited by unbalanced magnetron sputtering. The arithmetic roughness (Ra) of the films ranged between 2 and 10 nm and was measured by atomic force microscopy. The measured surface topography was incorporated into a finite element model, which allowed simulating the indentation...
متن کاملPrediction of Surface in Machining by Flat and Spherical Surface Tools
In this paper, the profile of surfaces machined using end mills with flat and ball end tools in modeled. The real kinematics of the tool motion, the static deflection and the run out of the tool are included in the model. The cutting forces are calculated using a semi-empirical method based on orthogonal to oblique conversion of cutting coefficients. The thickness of the uncut chip is used as t...
متن کاملChange of diffused and scattered light with surface roughness of p-type porous Silicon
Porous silicon samples were prepared by electrochemical etching method for different etching times. The structural properties of porous silicon (PS) samples were determined from the Atomic Force Microscopy (AFM) measurements. The surface mean root square roughness (σ rms) changes as function of porosity were studied, and the influence of etching time on porosity and roughness was studied too. U...
متن کاملChange of diffused and scattered light with surface roughness of p-type porous Silicon
Porous silicon samples were prepared by electrochemical etching method for different etching times. The structural properties of porous silicon (PS) samples were determined from the Atomic Force Microscopy (AFM) measurements. The surface mean root square roughness (σ rms) changes as function of porosity were studied, and the influence of etching time on porosity and roughness was studied too. U...
متن کاملLow-Carbon Steel Sheet Asymmetric Single-Point Incremental Forming: Analysis and Optimization of the Surface Roughness (TECHNICAL NOTE)
Surface roughness (SR) has an adverse effect on the appearance of low-carbon steel parts, formed in the asymmetric incremental sheet forming (AISF) process, particularly those requiring painting operation. The purpose of this study is to investigate the effects of AISF process parameters on the surface roughness of an asymmetric part formed on low-carbon steel sheets. The parameters are feed ra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallic Materials
سال: 2018
ISSN: 0023-432X
DOI: 10.4149/km_2017_6_413