Alloy Layer Structure Formed by High-temperature Aluminizing in Metal Mold Steel SKD61
نویسندگان
چکیده
منابع مشابه
Properties of Low-alloy High-speed Steel at Elevated Temperature
J. Jaworski, T. Trzepieciński: Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Rzeszów, Poland This paper presents the results of research on the determination of the coefficient of thermal conductivity and hot hardness of cutters made of selected grades of low-alloy high-speed steels, HS 6-5-2 and HS3-1-2. The investigations of hot hardness and yield stress...
متن کاملNeural Network Modeling of Oxidation Kinetics in Air of Steel- T21 Alloy Coated by Simultaneous Germanium-Doped Aluminizing-Siliconzing Process
In this work a pack cementation of germanium-doped aluminum and silicon coatings on low alloy steel type-T21 has been applied. This gives significant improvement in the oxidation. Steel-T21 was coated with germanium-doped aluminizing-siliconizing. Diffusion coating was carried out at 1050C for 6 h under an Ar atmosphere by simultaneous germanium-doped aluminizing-siliconzing process. Cyclic oxi...
متن کاملAn Evaluation of a Borided Layer Formed on Ti-6Al-4V Alloy by Means of SMAT and Low-Temperature Boriding
In this paper, a nanocrystalline surface layer without impurities was fabricated on Ti-6Al-4V alloy by means of surface mechanical attrition treatment (SMAT). The grain size in the nanocrystalline layer is about 10 nm and grain morphology displays a random crystallographic orientation distribution. Subsequently, the low-temperature boriding behaviors (at 600 °C) of the SMAT sample, including th...
متن کاملSimulation of conventional cold-formed steel sections formed from Advanced High Strength Steel (AHSS)
The objective of this paper is to explore the potential impact of the use of advanced high strength steel (AHSS) to form traditional cold-formed steel structural members. In this study, shell finite element models are constructed, and geometric and material nonlinear collapse analysis performed, on simulated lipped channel cross-section cold-formed steel members roll-formed from AHSS. AHSS shee...
متن کاملMechanism by which porous structure is formed on the surface of gold alloy containing only Cu as base metal.
Gold alloys with Cu contents of 10 mass%, 20%, and 30% were used for morphological observation of porous surface structures after heating at 800 degrees C in air followed by pickling with acid solution. With increasing Cu content in the gold alloy, the internal oxidation zone became well-developed in the alloy matrix. The mechanism by which a porous structure was formed on the surface of a gold...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2009
ISSN: 1883-2954,0021-1575
DOI: 10.2355/tetsutohagane.95.483