AISI 304 PASLANMAZ ÇELİĞİN SIVAMA PARAMETRELERİNİN SONLU ELEMANLAR YÖNTEMİYLE BELİRLENMESİ
نویسندگان
چکیده
منابع مشابه
Mechanical Characterization of Friction Welded AISI 304 Steels
There are many industries where austenitic stainless steel needs to be welded specially in power generation industries. Unfortunately the austenitic stainless welding has several fabrication and metallurgical drawbacks when welded by using conventional fusion welding methods, which can often leads to in-service failure. The most pronounced fabrication faults are hot cracks due to inadvertent us...
متن کاملSayisal Görüntü Anali̇z İşlemi̇nde Kamera Kali̇brasyon Parametreleri̇ni̇n Beli̇rlenmesi̇ Determination of Camera Calibration Parameters at Digital Image Analysis
It is possible to make measurements, to evaluate and form digital maps of the images by using digital image processing and analysis techniques with computers. Digital cameras are being used in computer vision applications commonly. Digital cameras have been absolutely calibrated to use precision need works. Photogrammetry is based on direct measurement of the objects which is captured with the ...
متن کاملEnhancement of corrosion protection of AISI 304 stainless steel by nanostructured sol–gel TiO2 films
0010-938X/$ see front matter 2013 Elsevier Ltd. All rights reserved. http://dx.doi.org/10.1016/j.corsci.2013.07.045 ⇑ Corresponding author. Address: Faculty of Mechanical Engineering and Naval Architecture, Departmet of Materials, Ivana Lučića 5, 10000 Zagreb, Croatia. Tel.: +385 1 616 8313; fax: +385 1 615 7126. E-mail address: [email protected] (L. Ćurković). Lidija Ćurković a,⇑, Helena ...
متن کاملDesign optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method
In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....
متن کاملA Cohesive Zone Model for Crack Growth Simulation in AISI 304 Steel
Stable ductile crack growth in 3 mm thick AISI 304 stainless steel specimens has been investigated experimentally and numerically. Multi-linear Isotropic Hardening method coupled with the Von-Mises yield criterion was adopted for modeling elasto-plastic behavior of the material. Mode-I CT fracture specimens have been tested to generate experimental load-displacement-crack growth data during sta...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Gazi Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi
سال: 2018
ISSN: 1300-1884
DOI: 10.17341/gazimmfd.406802