Advanced Friction Modeling in Sheet Metal Forming
نویسندگان
چکیده
منابع مشابه
Multiscale Friction Modeling for Sheet Metal Forming
The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes when two surfaces are in contact under a normal load. This is caused by flattening due to combined nor...
متن کاملMULTISCALE FRICTION MODELING FOR SHEET METAL FORMING Authors
The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes if two surfaces are in contact under a normal load which is an effect of flattening due to normal load...
متن کاملA Software Solution for Advanced Friction Modeling Applied to Sheet Metal Forming
In this paper, a software solution is presented for advanced friction modeling in metal forming processes, using a physically-based friction model. As input, the model requires the properties of the metal-lubricant combination used and the surface characteristics of the tooling and sheet material. As output, the friction coefficient is provided in both the boundary and mixed lubrication regime....
متن کاملAnalytical Modeling of Axi-Symmetric Sheet Metal Forming
The cup drawing is a basic deep drawing process. Thus, understanding the mechanics ofthe cup drawing process helps in determining the general parameters that affect the deep drawingprocess. There are mainly two methods of analysis; experimental and analytical/numerical.Experimental analysis can be useful in analyzing the process to determine the process parameters thatproduce a defect free prod...
متن کاملPrediction of Instability in Planar Anisotropic Sheet Metal Forming Processes
In this paper instability of planar anisotropic sheet metal during a few forming processes is investigated for the first time. For this reason components of the constitutive tangent tensor for planar anisotropic sheets are developed. By using the above tensor location of necking is predicted. Direction of the shear band is also predicted using the acoustic tensor. A finite element program is pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Key Engineering Materials
سال: 2011
ISSN: 1662-9795
DOI: 10.4028/www.scientific.net/kem.473.715