Active Trimming of Hybrid Integrated Circuits
نویسندگان
چکیده
منابع مشابه
Active Microfluidic Cooling of Integrated Circuits
The thermal management of high heat fluxes is a critical roadblock in the way of higher-performance microelectronics. The ongoing reduction in microtransistor size translates into heat fluxes comparable to those encountered in nuclear reactions and rocket nozzles, but under much severer temperature constraints. Although the average heat flux may remain in the vicinity of 100 to 300 W/cm, the pe...
متن کاملGraphene/Si CMOS Hybrid Hall Integrated Circuits
Graphene/silicon CMOS hybrid integrated circuits (ICs) should provide powerful functions which combines the ultra-high carrier mobility of graphene and the sophisticated functions of silicon CMOS ICs. But it is difficult to integrate these two kinds of heterogeneous devices on a single chip. In this work a low temperature process is developed for integrating graphene devices onto silicon CMOS I...
متن کاملLocalized in situ cladding annealing for post-fabrication trimming of silicon photonic integrated circuits.
We report the use of localized annealing via in situ heaters to induce a semi-permanent change in the refractive index of the cladding in ring resonator filters. When compared to other methods for post-fabrication trimming, this method has the advantage that no additional equipment, other than a supply of electrical power, is necessary to cause the index change. Two cladding materials were used...
متن کاملLaser micromachining of active and passive photonic integrated circuits
This thesis describes the development of advanced laser resonators and applications of laserinduced micromachining for photonic circuit fabrication. Two major advantages of laserinduced micromachining are direct patterning and writing on large areas of substrates at high speed following the exposure of laser light, without using complicated photomask steps. For passive photonic devices fabricat...
متن کاملMemristor-CMOS hybrid integrated circuits for reconfigurable logic.
Hybrid reconfigurable logic circuits were fabricated by integrating memristor-based crossbars onto a foundry-built CMOS (complementary metal-oxide-semiconductor) platform using nanoimprint lithography, as well as materials and processes that were compatible with the CMOS. Titanium dioxide thin-film memristors served as the configuration bits and switches in a data routing network and were conne...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ElectroComponent Science and Technology
سال: 1984
ISSN: 0305-3091
DOI: 10.1155/apec.11.231