A review on metallurgical features of hot-dip aluminized steel
نویسندگان
چکیده
Abstract Among the various surface modification processes, hot-dip aluminizing process has increasingly evoked considerable attention. This method proved to be commercially cost-effective and technically better than galvanizing. In contrast aluminized steel components, galvanized components cannot used in service conditions at elevated temperatures. During last few years, intensive research by researchers yielded new insights into metallurgical aspects of coating as-dipped annealed condition. The present review gives a bird’s eye view process, from early years its inception current on coating. progress thermodynamic studies, phase equilibria, identification, their crystallographic features have been traced this attempt. is not restricted briefing performed so far but also points out several issues discrepancies among results published literature. Special emphasis given development during annealing increasing horizon application alloy steels hot stamped conditions. Reference made state-of-the-art topics embracing computer simulation software sophisticated experimental techniques. However, lower hardness economy restrict wide hot-dipping process.
منابع مشابه
Titanium-Aluminum Oxide Coating on Aluminized Steel
In this study, a plasma electrolytic oxidation (PEO) process was used to form titanium-aluminum oxide coating on aluminized steel. The present work was mainly to study the effects of treatment time of PEO process on properties of the titanium coating. A potentiodynamic polarization corrosion test was employed to investigate the corrosion resistance of the coating. The friction coefficient and w...
متن کاملEffect of Chemical Composition of Steel on the Structure of Hot – Dip Galvanized Coating
P. Pokorny, J. Kolisko, L. Balik – Czech Technical University – Klokner Institute, Prague, Czech Republic P. Novak – University of Chemistry and Technology, Prague, Czech Republic This article describes the effect of the content of conventional steel impurity elements on the thickness and composition of the zinc layer. This article is focused primarily on low-temperature, batch hot-dip galvaniz...
متن کاملDESCRIPTION OF STRUCTURE OF Fe-Zn INTERMETALIC COMPOUNDS PRESENT IN HOT-DIP GALVANIZED COATINGS ON STEEL
P. Pokorny, J. Kolisko, L. Balik – Czech Technical University – Klokner Institute, Prague, Czech Republic P. Novak – Institute of Chemical Technology, Prague, Czech Republic The article is describing formation, composition, morphology and crystallographic characteristics of intermetalic compounds Fe Zn present in the coating formed during the process of low-temperature hot-dip galvanizing of ca...
متن کاملDetermination of Surface Topography and Composition of Cr-Free Pretreatment Layers on Hot Dip Galvanized Steel
Topography and composition of Cr-free, titanium-based pretreatment layers on hot dip galvanized steel were studied with scanning electron microscopy, atomic force microscopy, time of flight secondary ion mass spectrometry and Auger electron spectroscopy. A layer within the target coating weight range (4-10 mg Ti/m) for industrial coil coating processes contained a micro-structure with hillocks ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering research express
سال: 2023
ISSN: ['2631-8695']
DOI: https://doi.org/10.1088/2631-8695/acb902