A design of L-band second harmonic power amplifier
نویسندگان
چکیده
منابع مشابه
High-power operation of a K-band second-harmonic gyroklystron.
Amplification studies of a two-cavity second-harmonic gyroklystron are reported. A magnetron injection gun produces a 440 kV, 200-24S A, 1 ps beam with an average perpendicular-to-parallel velocity ratio slightly less than 1. The TED» input cavity is driven near 9.88 6Hz and the TE02& output cavity resonates near 19.76 6Hz. Peak powers exceeding 21 MW are achieved with an e%ciency near 21% and ...
متن کاملDesign of X Band High Power Amplifier MMIC Based on AlGaN/GaN HEMT
In this paper, we have presented an X band high power amplifier based on MMIC (Monolithic Microwave Integrated Circuit) technology for satellite remote sensing systems. We have used GaN HEMT process with 500 nm gate length technology with VD= 40 V and VG= -2 V in class E structure. The proposed two-stage power amplifier provides 25 dB power gain with maximum output power of 49.3 dBm at 10 GHz. ...
متن کاملDesign of Cartesian Feedback Rf Power Amplifier for L-band Frequency Range
A phase-alignment system is used fully integrate a power amplifier, Cartesian feedback linearization circuitry, and a phasealignment system. The phase-alignment system employs a new technique for offset-free analog multiplication that enables it to function without manual trimming. This paper demonstrates how the phase-alignment system improves the stability margins of the fully integrated Cart...
متن کاملBroadband RF Power Amplifier Design Methodology Using Sequential Harmonic Characterization
Radio Frequency Power Amplifier (RFPA) amplifies the communication signals to the required power level for transmission. It is the most power consuming stage in a transceiver chain; consequently, any improvement in terms of dissipated power and efficiency of the power amplifier affects the overall power budget of the transmitter. Also, efficient performance of the RF power amplifier over extend...
متن کاملdesign, optimization and analysis of high power amplifier in the ka band
the graphical technique for nonlinear circuits was described that enable us to optimize circuits to obtain maximum output power, maximum efficiency or minimum intermodulation. according to this method a high power amplifier in the ka band was designed. using a nonlinear model of the transistor, optimum slope for load-line was determined so that maximum power at the output was obtainable, then ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2021
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/1865/2/022074