A Bidirectional Communicating Power Supply Circuit for Smart Gate Driver Boards
نویسندگان
چکیده
منابع مشابه
Supply clock generation (driver) circuit for 2PASCL
The paper presents a new quasi adiabatic logic family that uses two complementary split-level sinusoidal power supply clock for digital low power applications such as sensors. The proposed two-phase adiabatic static CMOS logic circuit (2PASCL) is using the principle of energy recovery and adiabatic switching. It has switching activity that is lower than dynamic logic and can be directly derived...
متن کاملA Universal Soi-based High Temperature Gate Driver Integrated Circuit for Sic Power Switches with On-chip Short Circuit Protection
In recent years, increasing demand for hybrid electric vehicles (HEVs) has generated the need for reliable and low-cost hightemperature electronics which can operate at the high temperatures under the hood of these vehicles. A high-voltage and high temperature gate-driver integrated circuit for SiC FET switches with short circuit protection has been designed and implemented in a 0.8-micron sili...
متن کاملGate Driver Integrated Circuit with Breakdown Protection for Switch-mode Power Amplifiers
This paper proposes a gate driver integrated circuit to prevent breakdown of switching power amplifiers. The proposed circuit consists of a dead-time generator, level shifters, and a breakdown blocker. The dead-time generator makes non-overlapped input signals and the breakdown blocker detects instantaneous turned-on input signals and resets them to the off-state before the switching power cell...
متن کاملPower Bus Isolation Using Power Islands in Printed Circuit Boards
Power islands are often employed in printed circuit board (PCB) designs to alleviate the problem of power bus noise coupling between circuits. Good isolation can be obtained over a wide frequency band due to the large series impedance provided by the gap between the power islands. However, power bus resonances may degrade the isolation at high frequencies. The amount of isolation also depends o...
متن کاملIGBT Gate Driver Solutions for Low and Medium Power Applications
Issue 6 2010 Power Electronics Europe www.power-mag.com Power electronics systems are commonly used in motor drive, power supply and power conversion applications. They cover a wide output power spectrum: from several hundred watts in small drives up to megawatts in wind power installations or large drive systems. Inside the system the gate driver circuit with its extensive control and monitori...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Electronics
سال: 2020
ISSN: 0885-8993,1941-0107
DOI: 10.1109/tpel.2019.2960632