steel 2205 is one of the most famous duplex stainless steels. the microstructure of this steel composed of ferrite and austenite in similar amount. therefore, in order to improve mechanical properties through microstructure, thermo mechanical processes such as controlled hot rolling and forging should be applied. it is not possible to employ the usual heat treatment. it shows the importance of ...

Steel 2205 is one of the most famous duplex stainless steels. The microstructure of this steel composed of ferrite and austenite in similar amount. Therefore, in order to improve mechanical properties through microstructure, thermo mechanical processes such as controlled hot rolling and forging should be applied. It is not possible to employ the usual heat treatment. It shows the importance of ...

the flow stress of steel depends significantly on microstructural changes taken place during hot deformation processes. in hot deformation processes, the flow stress of steel is influenced by two main metallurgical phenomena, i.e. recovery and recrystallization, along with its chemical composition and thermo-mechanical parameters. the final mechanical properties of steel are also determined by ...

Abstract In this work, a support vector machine (SVM) model was developed to predict the hot deformation flow curves of AZ91 magnesium alloy. The experimental stress-strain curves, obtained from hot compression testing at different deformation conditions, were sampled. Consequently, a data base with the input variables of the deformation temperature, strain rate and strain and the output variab...

In this research the effect of initial microstructure on hot deformation behavior in terms of Ferrite-to-Austenite ratios is studied. Two types of stainless steels C1 and C2 were homogenizing heat-treated and deformed under hot compression examinations at temperatures 900ºC and 1100ºC at strain rate of 0.1s-1. The results showed that the flow stress levels of specimens are strongly r...

The grain size refinement of AISI 422 martensitic stainless steel in the temperature range of 950-1150 ºC was investigated by hot deformation tests. The deformed specimens were held at deformation temperature with delay times of 5 to 300s after achieving a strain of 0.3. The austenite grains exhibit a considerable growth at temperature higher than 1050˚C, while the grain coarsening is negligibl...

In this paper, properties of slab deformation in sizing press mill as one of the slab reduction processes in hot rolling mills have been evaluated using the elastoviscoplastic finite element method with explicit formulation. Effect of prarameters such as initial slab width and thickness, reduction, feed pitch, and anvil speed on factors such as dogbone formation, head and tail fishtail profile,...