asymmetric membranes are widely used in many industrial membrane separation processes. the major advantage of membrane filtration over the conventional process is its ability to remove a wider spectrum of particles without using any chemicals. hollow fiber configuration offer many advantages over flat-sheet or tubular membranes. the spinning process of hollow fiber may look simple, yet it is te...

in this study, the effects of oleothermal modification on physical and mechanical peroperties of fir wood (abeis sp.) blocks were examined. at first, some blocks of fir wood with 5 × 20 × 120 cm dimensions were prepared. the blocks were treated in soybean oil. the effects of 3 factors such as treatments temperature (180and 200 °c), holding time (12 and 15 h) and initial moisture content of wood...

rivers and runoff have always been of interest to human beings. in order to make use of the proper water resources, human societies, industrial and agricultural centers, etc. have usually been established near rivers. as the time goes on, these societies developed, and therefore water resources were extracted more and more. consequently, conditions of water quality of the rivers experienced rap...

gol-e-gohar iron ore mine of sirjan in southern part of iran is a large open pit that operates below the groundwater table and during mining operation, dewatering is required to prevent operation processes from flooding. current operation is going on by digging wells in or out of the pit and pumping to prevent flooding. as a result of the former dewatering operation a vast deep cone of depressi...

run-out-table (rot) is located between last finishing stand and down coiler in a hot strip mill. as the hot steel strip passes from rot, water jets impact on it from top and bottom and strip temperature decreases approximately from 800-950 °c to 500-750°c. the temperature history that strip experience while passing through rot affects significantly the metallurgical and mechanical properties, s...

nowadays, air pollution is a global problem that has had significant growth by technology development, population growth andindustrial development. industrial development brought natural resources deterioration, more manufacturing products, and more environmental pollutants. if pollutant won’t be controlled, human-being and wildlife will face the critical risks. significant release and critical...

drought is transient phenomenon , slow , repetitive and integral part of the climate of each region. drought begins with a substantial reduction in precipitation over the long-term average rainfall and over time, reduced soil moisture and surface and ground water resources will continue to decrease. this phenomenon is the most important in bakhtegan basin because of its importance in strategic ...

there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...