In this paper we present Three-Valued Spatio-Temporal Logic (TSTL), which enriches the available spatio-temporal analysis of properties expressed in Signal Spatio-Temporal Logic (SSTL), to give further insight into the dynamic behaviour of systems. Our novel analysis starts from the estimation of satisfaction probabilities of given SSTL properties and allows the analysis of their temporal and s...

The Singwi, Sjölander, Tosi, Land (SSTL) approach is generalized to study the spin–correlation effects in a one dimensional electron gas. It is shown that the SSTL approach is capable of generating results comparable to the more widely used STLS approach. e-mail: [email protected] e-mail: [email protected]

This paper presents the design of a compact ultra-wideband (UWB) bandpass planar filter with a tunable notched band within the bandwidth. The filter can be used for wireless communications within the unlicensed UWB range (3.1-10.6 GHz). The UWB filter is based on external interdigitated quarterwavelength microstrip resonators and a central half-wave microstrip resonator embedding a reconfigurab...

We have proposed a novel type of bandpass plasmonic filter consisting of metal-insulator-metal bus waveguides coupled with a series of side-coupled cavities and stub waveguides. The theoretical modeling demonstrates that our waveguide-resonator system performs a plasmonic analogue of electromagnetically induced transparency (EIT) in atomic systems, as is confirmed by numerical experiments. The ...

In this paper, a new method for designing an active dual-band dipole antenna is proposed. The operating frequencies of the proposed antenna are 150 and 450 MHz that are usually used in military applications. Using a series stub is the main idea in the proposed dual-band antenna, where it makes an independent resonance frequency higher than the main resonance frequency of a conventional dipole. ...

With the scaling of CMOS transistors and advance in I/O circuitry, the data rate of memory interfaces has recently reached 16Gb/s per channel [1], in which a point-to-point channel is required rather than a multi-drop channel for the high data rate. While point-to-point channels are advantageous in achieving higher data rates because of the absence of undesired reflections that occur at each st...

We use the SSTL (Singwi, Sjölander, Tosi, Land) approximation to investigate the short–range correlations in a one dimensional electron gas, for the first time. Although SSTL is introduced to better satisfy the compressibility sum rule in three dimensions, we show that the widely used STLS (Singwi, Tosi, Land, Sjölander) approximation is more successful in the case of the one dimensional electr...

The multi band microstrip antenna is realized either by placing stub on the edges of the patch or by cutting slots at an appropriate position inside the patch or by using the combination of these two methods. In this paper an analysis to study the effects of stub and slot in dual stub loaded and stub loaded pair of rectangular slot cut rectangular microstrip antennas is presented. The additiona...

Recently, several designs of single fed circularly polarized microstrip antennas have been studied. Relatively, a few designs for achieving circular polarization using triangular microstrip antenna are available. Typically existing design of single fed circularly polarized triangular microstrip antennas include the use of equilateral triangular patch with a slit or a horizontal slot on the patc...

This paper demonstrates a power supply noise reduction using on-board stubs. A quarter-length stub attached to the power supply line of an LSI chip works as a band-eliminate filter, and suppresses the power supply noise of the designed frequency. Preliminary experiments show that 87% of the designed frequency noise component is suppressed when stub patterns are written on a power supply area on...