Cu/x-SiO2 catalysts with 4, 10, and 20 nm silica sols as supports was produced by ammonia evaporation method and characterized. Different nano-sized silica sols as supports significantly affected the structure and catalytic properties of the copper catalysts for ethylene glycol synthesis from dimethyl oxalate. Compared with Cu/20-SiO2 and Cu/4-SiO2 catalysts, the catalytic performance and stabi...

The influence of catalyst support alumina-silica in terms of different Al2O3 to SiO2 mole ratios containing 20 wt.% Ni on the production of hydrogen and catalyst coke formation from the pyrolysis-catalysis of waste tyres is reported. A two-stage reactor system was used with pyrolysis of the tyres followed by catalytic reaction. There was only a small difference in the total gas yield and hydrog...

The influence of Sn2+doping on the structure and performance of silica supported copper catalyst was systematically investigated and characterised. Catalytic evaluation showed that the suitable content of Sn2+ introduced into a Cu/SiO2 catalyst evidently improved the catalytic activity and stability of ethylene glycol synthesis from dimethyl oxalate. X-ray diffraction and X-ray auger electron s...

The variation of the supports on the Cu/SiO2 catalyst plays an important role in the catalytic performance for hydrogenation of dimethyl oxalate. The loss of silica in the form of tetramethoxysilane from the support under the reaction conditions is responsible for the deactivation of the Cu/SiO2 catalyst.

A weak surface modification is applied to Co/SiO2 catalyst by hydrothermal treatment at 180°C for 5 h. Aluminum is introduced to Co/SiO2 catalysts during the surface modification. The effects of surface modification on Co/SiO2 catalyst are studied by changing the operating sequences of surface modification and cobalt impregnation in the catalyst preparation. Surface modification before cobalt i...

a simple, green and efficient method for synthesis of 2,4,5-trisubstituted imidazoles is described via three-component cyclocondensation of benzil or benzoin, aldehyde and ammonium acetate by using the nano sio2-supported ferric hydrogen sulfate (fhs/sio2), as a catalyst, under solvent-free conditions. the nano sio2 support and catalyst were characterized by x-ray diffraction (xrd), transmissio...

In this paper, silica gel supported titanium dioxide particles (TiO2/SiO2) prepared by acid-catalyzed sol–gel method was as photocatalyst in the degradation of acid orange 7 (AO7) in water under visible light irradiation. The particles were characterized by X-ray diffraction, BET specific surface area determination, and point of zero charge measurement. The supported catalyst had large surface ...

tio2 photo catalyst was prepared in presence of nano sio2 and hydroxy propyl cellulose (hpc) by sol gel method with titanium tetra isopropoxide (ttip) as titanium precursor. additional effect of hpc in preparation of nano catalyst, and photo catalyst properties measured and characterized by ft-ir, ft-raman and sem. the catalyst size and structural properties of the film were determined by .-ray...

A nitrogen-doped mesoporous carbon containing a network of carbon nanotubes (CNTs) was produced for use as a catalyst for the oxygen reduction reaction (ORR). SiO2 nanoparticles were decorated with clusters of Fe atoms to act as catalyst seeds for CNT growth, after which the material was impregnated with aniline. After polymerization of the aniline, the material was pyrolysed and the SiO2 was r...