the study of interactions of jet into cross flow at different longitudinal and transverse angles ofjet was studied. the following components were designed and constructed: a low velocity windtunnel to produce the uniform flow, a flat plate with a traverse injection system to simulate the jetinjection, and a spatial rake to measure the total pressure. the tests were carried out atlongitudinal (α...

abstract in the present article, effective parameters of the buoyant jets have been evaluated in the stagnant ambient fluid. the jet parameters, geometry parameters and environmental parameters are investigated. using dimensional analysis, a set of dimensionless functions was obtained. to achieve the exact functions, a physical model was built in the hydraulic laboratory of shahid chamran unive...

the effect of a combined system of the bed suction and jet injection as a pier-scour countermeasure on the turbulent flow field is studied in a laboratory flume using an acoustic doppler velocimeter (adv). the three components of the velocities in the vertical symmetry plane in the equilibrium scour hole in front and rear of the pier under 3-jet injections and bed suction rate qs/q0 = 2%located...

the spray characteristics of the fuel greatly influence emissions from diesel engines. spray development plays a vital role in improving the combustion and emission characteristics of fuel because it directly affects the air- fuel mixture formation. the spray characteristics of fuel mainly depend on fuel injection process, fuel density, fuel viscosity, ambient pressure and temperature. among th...

The mixing of air jets into hot, fuel-rich products of a gas turbine primary zone is an important step in staged combustion. Often referred to as “quick quench,” the mixing occurs with chemical conversion and substantial heat release. An experiment has been designed to simulate and study this process, and the effect of varying the entry angle (0°, 22.5°, and 45° from normal) and number of the a...

How to effectively transfer and exert a pressure on drills in lateral drilling, and to raise the efficiency of rock-breaking and rate of penetration in a bid, is the key technology to improve the quality, speed and economic benefits of lateral drilling. Therefore, based on high pressure jet of 16-hole and 7-hole nozzles, which are suitable for lateral drilling in oilfield at the present stage, ...

Numerical simulation has been performed by solving full Navier–Stokes equations governing the three-dimensional unsteady compressible flows. The main goal of the present work is to investigate the flow characteristics of a square jet issuing transversally into a cross-flow at three injection angles of 90°, 60° and 30°, and thus to provide some deeper insights into the physical flow mechanism go...

We investigate numerically the ability of three models (jet, structured outflow, energy injection) to accommodate the optical light-curve breaks observed in 10 GRB afterglows (980519, 990123, 990510, 991216, 000301c, 000926, 010222, 011211, 020813, and 030226), as well as the relative intensities of the radio, optical, and X-ray emissions of these afterglows. We find that the jet and structured...

The study of interactions of jet into cross flow at different longitudinal and transverse angles of jet was studied. The following components were designed and constructed: a low velocity wind tunnel to produce the uniform flow, a flat plate with a traverse injection system to simulate the jet injection, and a spatial rake to measure the total pressure. The tests were carried out at longitudina...

Numerical studies have been carried out using a validated two-dimensional standard k-omega turbulence model for the design optimization of a thrust vector control system using shock induced self-impinging supersonic secondary double jet. Parametric analytical studies have been carried out at different secondary injection locations to identifying the highest unsymmetrical distribution of the mai...