the nafion 117 membrane was doped with sio2 particles by sol-gel reaction. the reaction conditions to minimize leaching were investigated by using full factorial design of experiment. the results from the full factorial analysis indicated that the lowest amount of leaching takes place at 60oc without addition of acid and swelling of membranes prior to the reaction. the membranes, prepared at op...

There are several obstacles to the commercialization of PEM fuel cells.  One of the reasons is that the presence of carbon monoxide (CO) in the reformatted fuel, even at a very small scale, decreases the fuel cell performance. The aim of this paper is to investigate the effect of CO in reformatted fuel on PEM fuel cell performance. For this purpose, a steady state, one-dimensional and non-isoth...

in order to present a new and high performance structure of pem fuel cell and study the influence of the flow direction and distribution on the rate of reactants diffusion, three novel models of vertical reactant flow injection into the anode and cathode reaction area field have been introduced. they consist of one inlet and two inlets and also a continuous channel. the governing equations on t...

In order to present a new and high performance structure of PEM fuel cell and study the influence of the flow direction and distribution on the rate of reactants diffusion, three novel models of vertical reactant flow injection into the anode and cathode reaction area field have been introduced. They consist of one inlet and two inlets and also a continuous channel. The governing equations on t...

in this research the simulation of an air independent proton exchange membrane fuel cell (pemfc) propulsion system was taken into consideration. the system consists of several parts including pem fuel cell stack, metal hydride and liquid oxygen (lox) tanks, and also pre-heaters of oxygen and hydrogen gases along with other heat exchangers, to ensure proper operation of system. the heat recovery...

The development of polymer electrolyte membrane (PEM) fuel cells that can be operated over a wide temperature range without the need for humidification is highly desirable for vehicle applications to overcome the problems associated with CO poisoning and water management. Here we report a novel PEM based on 1H-1,2,4-triazole grafted polysiloxane doped with phosphoric acid and reinforced with po...

Maximum Power Point (MPP) tracker has an important role in the performance of fuel cell (FC) systems improvement. Tow parameters which have effect on the Fuel cell output power are temperature and membrane water. So contents make the MPP change by with variations in each parameter. In this paper, a new maximum power point tracking (MPPT) method for Proton Exchange Membrane (PEM) fuel cell is pr...