the forging model for cold rolling is one of rolling models that is used in rolling calculations. in this model,the final rolling pressure is an average value and it is not an accurate model.also by using this model,the firction hill curves are plotted due to the central point of the rolling bite length while frictional stresses intersect at the neutral point.in this study, a new model based on...

the previous studies show that a high percentage of traffic accidents take place in two-lane rural highways and most of which happen at horizontal curves. meanwhile the horizontal alignment is often subject to hard topographic conditions where because of economic aspects designers are forced to design horizontal curves at grades. vertical angle of longitudinal slope reduces the normal force of ...

in the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. in this study, a series of compression tests were simulated using abaqus software. in this study, it has been employed the taguchi method to design experiments by the factor...

In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...

With the uncertainty regarding global energy future, ability to lubricate concentrated contacts with sufficiently thick liquid films while minimizing friction is of extreme importance. The assumptions classical elastohydrodynamic lubrication have remained unchanged since early days. It has not been possible test many these without measurement viscosity at (EHL) pressures, and viscometer measure...

There are several parameters that have significant influence in metal forming process. One of the most important of them is friction coefficient. Friction can change the pattern of metal flow and the force needed for deformation. It is necessary to determine the friction coefficient to study the effect of friction on metal forming process. This study is concerned with numerical and experimental...

Two distinct regimes are considered when it comes to friction: gross-sliding regime and presliding regime [1]. Friction in the gross-sliding regime contains familiar and classic concepts of static friction, Coulomb friction, and Stribeck curve. It is more intriguing, on the other hand, that friction in the pre-sliding regime behaves like a non-linear spring with hysteresis, significantly impact...

Two distinct regimes are considered when it comes to friction: gross-sliding regime and presliding regime [1]. Friction in the gross-sliding regime contains familiar and classic concepts of static friction, Coulomb friction, and Stribeck curve. It is more intriguing, on the other hand, that friction in the pre-sliding regime behaves like a non-linear spring with hysteresis, significantly impact...

objective: to investigate the friction of rabbit’s knee joint with designed pendulum friction tester to diagnose and evaluate different pathological and therapeutic conditions following haemarthrosis, osteoarthritis, and other joint disorders. materials and methods: friction coefficient of 10 adult male albino rabbit’s joint (5 right and 5 left knees) weighted 1.59 ± 0.27 kg, after designing a...