this study presents the electric behavior of sandwich devices based on porous silicon (ps) thin films with au/ps/si/cu structure when the material’s surface is exposed to different gases. ps thin films were fabricated by the electrochemical anodization method of si–c (100) substrates with resistivity 1.4-2.6 ωcm. samples were anodized in a solution of hf (48%), c2h5oh (99.98%) and distilled wat...

An efficient and convenient synthesis of novel tetrahydrobenzo[c]acridin-8(7H)-one derivatives is described using the electrogenerated anion of acetonitriles as the base in the presence of tetrabutylammonium fluoride as an effective supporting electrolyte in a one-pot, three-component condensation of aromatic aldehyde, dimedone and 1-naphthyl amine. The reaction is carried out in an undivided c...

Composite coatings synthesized by different morphologies of CeO2 in supergravity devices are highly active in hydrogen evolution reactions (HERs). By adding CeO2 nanoflakes (CeO2 Nf) or CeO2 nanorods (CeO2 Nr), the change in the microstructures of composites becomes quite distinct. Moreover, most Ni–S alloys are attached on the surface of CeO2 and roughen it compare with pure CeO2. In order to ...

Zinc was electrodeposited from an acidic sulphate solution on commercial steel sheet substrates galvanostatically at 10, 20, and 100 mA/cm2. The steel substrates had an average roughness number of 1.34 microns and a high percentage of its grains had their (111) planes parallel to the plate surface. During electrodeposition at 10 mA/cm2, on some specimens, there was an intense potential fluctuat...

Zinc was electrodeposited from an acidic sulphate solution on commercial steel sheet substrates galvanostatically at 10, 20, and 100 mA/cm2. The steel substrates had an average roughness number of 1.34 microns and a high percentage of its grains had their (111) planes parallel to the plate surface. During electrodeposition at 10 mA/cm2, on some specimens, there was an intense potential fluctuat...

A comparison of charging results obtained with Quantox and CHARM-2 is presented for the case of Arsenic implants at 80 KeV and 20 KeV, performed at doses of 5e14 /cm2 and 5e15 /cm2 at beam currents of 9 mA and 18 mA. The surface potential maps obtained by the Quantox are compared to the potentials and currents measured on the CHARM sensors, with the plasma charge control system on and off. Th...

in the present study, ptruce/mwnts nanocatalysts synthesized via polyol process technique are applied as anode electro-catalyst in methanol electro-oxidation reaction (mor). to characterize the nanocatalysts, tem, xrd, eds and xps are investigated. cyclic voltammetry and choronoamperometry are used to evaluate the electro-catalytic activity and stability of the catalysts in methanol electro-oxi...

In this study, calcium-phosphate (Ca-P) and graphene oxide (GO)/ calcium-phosphate (Ca-P) coatings were electrodeposited with different pulsed current densities on TiO2 nanotubes. Results showed that the co-electrodeposition rate in the presence of GO, especially at low current densities of 2 and 5 mA/cm2, significantly decreased. This might be due to the large size of GO sheets as compared to ...