In order to establish titanium welding technology TIG arc weldability and MIG arc weldability were surveyed. For TIG arc weldability influence of arc length and thickness to proper region of welding condition became obvious. For MIG arc weldability a new method to defend wandering phenomenon was developed.

The basic weldability of the alloy Al-2.2Li-2.7Cu was investigated and compared with two common aluminum alloys: 2024 and 5083. The basic weldability was characterized by the susceptibility of the alloy to hot tearing as determined by the trans-Varestraint test. The hot tearing susceptibility was characterized through plots of total crack length and maximum crack length versus augmented strain....

Introduction ................................................................................................................................1 Overview of Weldability of Nickel-Base Superalloys..................................................................1 Crystallography............................................................................................................................

Ti and Ti alloys have been widely applied to biomedical and dental fields and the demands for their applications have increased gradually in these fields. Ti and its alloys have been used as biomaterial because of their high corrosion resistance, low toxicity, low elastic modulus and low density. Their defects are low shear strength, low wear resistance, low weldability, low formability and low...

The understanding of the hardenability is important in steel development with respect to weldability of steels as well as to the design of quenched and tempered steels. The common way to judge if steel is suitability to welding is the use of a carbon equivalent, which reflects the alloy content to the hardenability of the heat affected zone (HAZ). Most common of these equivalents is the IIW car...

The microstructures and weldability of a brazed joint of 1Cr18Ni9Ti austenitic stainless steel with BNi-2, BNi82CrSiBFe and BMn50NiCuCrCo filler metals in vacuum were investigated. It can be observed that an interdiffusion region existed between the filler metal and the base metal for the brazed joint of Ni-based filler metals. The width of the interdiffusion region was about 10 μm, and the mic...

This paper is a summary of master thesis written in the fall of 2015 in the department of Product Development in Jonkoping University in Sweden as a part of a research project with focus on the implementation and management of systems for design automation and design for manufacturing. It includes an implementation with the aim of enhancing a system currently in operation at an aerospace suppli...

modern vehicle bodies make intensive use of high strength steel grades to meet the contradicting demand of lighter weight and simultaneously better mechanical performance. for many steel grades microalloying by niobium is the key to achieve their characteristic property profile. in hsla steels niobium enhances the strength primarily by grain refinement. in interstitial free high strength steels...

The 25Cr-35Ni heat resistant steel has been widely used when resistance to oxidation and creep rapture at elevated temperatures is required. In this paper, the microstructural effect on the weldability of this alloy is investigated. The results of this study indicate that this steel has a perfect weldability in the as cast condition but does not possess good weldability in the aged condition. T...