in this research formability behavior and texture of st14 low carbon steels produced by foolad mobarakeh plant for deep drawing application had been studied. plate textures were characterized by x-ray diffraction technique. to evaluate formability behavior one dimensional tensile test was carried out and related parameters were recognized. moreover eriksson experiment and spherical pattern prin...

OBJECTIVE This study determined the ultimate tensile strength (UTS) of enamel (E), dentin (D) and dentin-enamel junction (DEJ) using the microtensile technique. It was hypothesized that the UTS of dental structures varies according to location and nature. METHODS Intact occlusal enamel surfaces from extracted human third molars were etched with 37% phosphoric acid and bonded with a one-bottle...

in the present work, the effect of aluminum content, austenitizing temperature and austempering time and temperature on the mechanical properties and hardness of fe-c-al grey cast iron was investigated. for this purpose, three alloys containing 1, 2 and 4 weight percent of aluminum were provided. the tensile samples were austenitized at 850?c and 900?c for 120 min, followed by austempering proc...

Pressurized water reactor (PWR) cores operate under extreme environmental conditions due to coolant chemistry, operating temperature, and neutron exposure. Extending the life of PWRs requires detailed knowledge of the changes in mechanical and corrosion properties of the structural austenitic stainless steel components adjacent to the fuel (internals) that are inherent to such conditions. This ...

We examined macroscopically and microscopically 55 cadaver rotator-cuff tendons attached to their humeral heads to determine the distance between the edge of the articular cartilage and the tendon insertion of the supraspinatus (the width of the sulcus) and the score of regressive changes at the sulcus. In 33 specimens we measured the tensile strength. The width of the sulcus was correlated wit...

In this paper, the effect of different alloying elements on the ultimate tensile strength of Al-Mg2Si composites is theoretically studied. The feed forward back propagation neural network with sigmoid function is used. The extensive experimental results taken from literature are modeled and mathematical formula is presented in explicit form. In addition, it is observed that magnesium and copper...

We investigated the effect of welding parameters on ultimate tensile strength of structural steel, ST37-2, welded by Metal Active Gas welding. A fractional factorial design was used for determining the significance of six parameters: wire feed rate, welding voltage, welding speed, travel angle, tip-to-work distance, and shielded gas flow rate. A regression model to predict ultimate tensile stre...

in this paper, a new method is proposed for the production of mwcnts/pvc (multi-walled carbon nanotubes/ polyvinyl chloride) nanocomposites. in this method, a spray is used to produce layers of carbon nanotubes within a pvc matrix. various parameters influence the production of the nanocomposite and its mechanical properties. these parameters are studied separately and the effect of each of par...

Polyetheretherketone (PEEK) was reinforced with 0-40 vol% hydroxyapatite (HA) whiskers using a novel powder processing and compression molding technique. A powder mixture was uniaxially pressed into a composite powder compact and compression molded into a flat composite bar using an open-channel die, such that the HA whiskers exhibited a preferred orientation along the length of the bar and ten...

In this experimental work, Manganese oxide (MnO2), Zinc oxide (ZnO), Iron oxide (Fe2O3) and Magnesium chloride (MgCl2) were used as activating flux to investigate the effects for SS 304 in tungsten inert gas (TIG) welding. Ultimate tensile strength, percentage elongation, Penetration depth and width were studied of material SS 304. The experimental results indicated that the MnO2 and Fe2O3 flux...