the purpose of this study is to improve the aerodynamic performance of wind turbine blades, using the ball-spine inverse design method. the inverse design goal is to calculate a geometry corresponds to a given pressure distribution on its boundaries. by calculating the difference between the current and target pressure distributions, geometric boundaries are modified so that the pressure differ...

in the current work, different methods for optimization of turbine blade internal cooling are investigated, to achieve higher cyclic efficiency and output power for a typical gas turbine. a simple two-dimensional model of c3x blade is simulated and validated with available experimental data. the optimization process is performed on this model with two different methods. the first method is a po...

High-pressure air enters the air-turbine of the dental handpiece and strikes the blades to drive the impeller. The air-turbine has impeller and the air tube is connected to the air-turbine housing. The flowfield of the air-turbine were investigated for the optimum air-turbine design using ANSYS CFX. The objective of the research was to find an optimum design variables for the air-turbine to inc...

in high-pressure axial turbines, when the fluid mass flow is low, the supersonic blades are being used to obtain a high specific work output. to prevent losses due to low blade aspect ratio, the turbine is used in partial admission conditions. the turbine stator is a group of convergence-divergence nozzles that provides the supersonic flow. the design of these nozzles is important, because ther...

a comprehensive review of fatigue behavior and fatigue design of heavy section wind turbine castings made of ductile iron en-gjs-400-18-lt is performed. common metallurgical defects that are affecting fatigue behavior of this material were studied. review of different researches on quantitative effect of chunky graphite and micro structure on fatigue behavior of en-gjs-400-18-lt was performed. ...

Constantly rising operating pressure and temperature in turbine drivers push the material capabilities of turbine blades to the limit. The recent development of heterogeneous objects by layered manufacturing offers new potentials for the turbine blades. In heterogeneous turbine blades, multiple materials can be synthesized to provide better properties than any single material. A critical task o...

The combined cycle power plant is made up of three major systems, the gas turbine engine, the heat recovery steam generator and the steam turbine. Of the major systems the gas turbine engine is a fixed design offered by a manufacturer, and the steam turbine is also a fairly standard design available from a manufacturer, but it may be somewhat customized for the project. In contrast, the heat re...

In the current work, different methods for optimization of turbine blade internal cooling are investigated, to achieve higher cyclic efficiency and output power for a typical gas turbine. A simple two-dimensional model of C3X blade is simulated and validated with available experimental data. The optimization process is performed on this model with two different methods. The first method is ...

A detailed review of the current state-of-art for wind turbine blade design is presented, including theoretical maximum efficiency, propulsion, practical efficiency, HAWT blade design, and blade loads. The review provides a complete picture of wind turbine blade design and shows the dominance of modern turbines almost exclusive use of horizontal axis rotors. The aerodynamic design principles fo...

a wind turbine transformer (wtt) is designed using a 3d wound core while the transformer’s total owning cost (toc) and its inrush current performance realized as the two objective functions in a multi-objective optimization process. multi-objective genetic algorithm is utilized to derive pareto optimal solutions. the effects of inrush current improvement on other operating and design parameters...