For some electrostatic precipitators, profiled steel sheets are used as casing wall which is subjected to both bending and vertical compression. By nonlinear finite element method, the influences of structural parameters on load bearing capacity of profiled steel sheet wall were investigated. For the loading path, the uniform transversal pressure was applied firstly, and then the vertical compr...

An Al/Stainless Steel/Al lamellar composite was produced by roll bonding of the starting sheets at 400 °C. Afterward, the roll bonded sheet was cut in half and the accumulative roll bonding (ARB) process at room temperature was applied seven times. As a result, the central steel layer fractured and distributed in the Al matrix among different layers introduced by the repetition of roll bonding ...

A new type of bake-hardenable high strength hotrolled sheet steel was developed, which shows remarkable increase in tensile strength as well as yield strength after strain age hardening without addition of special elements. The new sheet steel possesses excellent crashworthiness and high fatigue strength, and also shows good formability almost equal to that of conventional high strength sheet s...

A numerical framework for the simulation of sheet steel stamping forming is presented. The main problems, the equations of motion, the constitutive relation, the initial conditions, boundary conditions and contact conditions, are presented in detail. Based on this, the finite element model is established and solved for exploring the changes in laws of stress, strain and so on. The information o...

This study was aimed to explain the influence of surface roughness of the drawbead on non-symmetry deep drawing cold rolled steel sheet to improve the drawability of cold rolled steel sheet. The variables used in this study included semi-circle drawbead with 3 levels of surface roughness which are 6.127 μm Ra, 0.963 μm Ra and 0.152 μm Ra and cold rolled steel sheet according to 3 grades of the ...

Towards the goal of providing a continuous process for the solid-state fabrication of carbon nanotube sheets and yarns from carbon nanotube forests, we report the growth of yarnspinnable and sheet-drawable carbon nanotube forests on highly flexible stainless steel sheets, instead of the conventionally used silicon wafers. Sheets and yarns were fabricated from the 16 cm maximum demonstrated fore...

In order to lower fuel consumption and reduce emissions, aluminum is being considered as an alternative to steel in large scale production of autobodies. This study evaluates the prospects of aluminum sheets as a cost efficient alternative to steel in autobodies with the unibody design. The study focuses on the processing technologies and alloy selection for aluminum automotive sheets and looks...

the objectives in the cold rolling process include improved sheet surface quality, enhanced steel mechanical strength, and better solidification operations. given the increasing demand for higher steel surface quality, more rapid production, and thinner steel plates, more attention has been directed toward the parameter of temperature in cold rolling as a means of achieving the above objectives...

This paper describes an alternative finite element model that would yield more accurate results in the prediction of the behavior of Profiled Steel Sheet Dry Board (PSSDB) folded plate structures, which can be considered as an improvement of an earlier proposed model. The PSSDB folded plate structures are being proposed as an alternative to traditional forms of roof construction.The PSSDB syste...