the use of twb has been developed in automotive industries because of it’s advantages such as reduction in weight, cost and fuel economy of vehicles. the main objective of the peresent work is to study the effects of weld zone, diffrence in surface coating and thickness ratio on the formability of twb composed of aisi 304, spcc and if steel sheets. it was found that the narrow weld zone has lit...

This paper deals with characteristics of interior permanent magnet synchronous motor considering anisotropic characteristics of electrical steel sheets. Motor characteristics of back electro-motive force (EMF), d-q axis inductances, and core loss are calculated by FEA considering anisotropy of electrical steel sheets and compared to the results from experiment and general FEA; using single mate...

Rapid development of automotive industry brings also increased requirements for sheets properties, involving relatively high strength and good formability together with excellent corrosion resistance. Increasing requests for corrosion resistance lead to the production of coated car parts, protected mainly by zinc coatings. Whereas, majority of European producers of passenger cars use preferenti...

TWIP-cored three-layer steel sheets were newly fabricated by hot rolling of TWIP steel sheet surrounded by low-carbon (LC) or interstitial-free (IF) steel sheets. TWIP/LC or TWIP/IF interfaces were well bonded without pores or voids, while a few pearlites were thinly formed along the interfaces. The strengths and elongation of the TWIP-cored sheets increased as the volume fraction of TWIP-cored...

in this paper, the effect of cyclic loading on punching strength of flat slabs strengthened with carbon fiber reinforced polymer (cfrp) sheets is studied. experimental results of ten slab specimens under monotonic and cyclic loading are analyzed. eight specimens were strengthened with cfrp sheets on the tensile face of the slabs and the two other specimens were kept un-strengthened as control s...

INTRODUCTION Intravascular coronary stenting has been used in the treatment of coronary artery disease (CAD), with a major limitation of in-stent restenosis (ISR). The 316 stainless steel has been widely used for coronary stents. In this study, we developed a novel coating method to reduce ISR by simultaneously coating vascular endothelial growth factor (VEGF) and anti-CD34 antibody on 316L sta...

a large number of bridges and buildings that are currently used, are made of slabs with opening. some of these buildings and bridges have been severely damaged because of natural disasters such as earthquake, storm and other effects such as materials fatigue and alkaline and corrosive agents. therefore, retrofitting and strengthening of these structures is essential and affordable. in this rese...

A special instrument has been built to measure the coercivity directly on steel sheets without having to cut samples. It will be used to perform the 8000 coercivity measurements which will be needed during the production of the ll'OOO ton of steel sheets for the LEP dipole magnets. The coercimeter allows local and directional coercivity measurements to be made on a steel sheet with an accuracy ...

This study investigates the mechanical behavior of steel fiber-reinforced concrete (SFRC) beams internally reinforced with steel bars and externally bonded with carbon fiber-reinforced polymer (CFRP) sheets fixed by adhesive and hybrid jointing techniques. In particular, attention is paid to the load resistance and failure modes of composite beams. The steel fibers were used to avoiding the rip...