Seth’s transition theory is applied to the problems of thickness variation parameter in a thin rotating disc by finite deformation. Neither the yield criterion nor the associated flow rule is assumed here. The results obtained here are applicable to compressible materials. If the additional condition of incompressibility is imposed, then the expression for stresses corresponds to those arising ...

Steady-state creep response in a rotating disc made of Al-SiC particle composite having linearly varying thickness has been carried out using isotropic/anisotropic Hoffman yield criterion and results are comparedwith those using vonMises yield criterion/Hill’s criterion ignoring difference in yield stresses. The steady-state creep behavior has been described by Sherby’s creep law. The material ...

Stresses for the elastic-plastic transition and fully plastic state have been derived for a thin rotating disc with inclusion and results have been discussed numerically and depicted graphically. It has been observed that the rotating disc with inclusion and made of compressible material requires lesser angular speed to yield at the internal surface whereas it requires higher percentage increas...

The flow in an elastico-viscous fluid between two co-axial infinite rotating porous discs is considered for high cross flow Reynolds number. The discs are rotating with different angular velocity and the injection rate of the fluid at one disc is different from the suction rate of other disc. The effect of suction parameters on the velocity components have been investigated numerically and solv...

In this paper, we explore the gravitomagnetic interaction of a black hole (BH) with a misaligned accretion disc to study BH spin precession and alignment jointly with BH mass MBH and spin parameter a evolution, under the assumption that the disc is continually fed, in its outer region, by matter with angular momentum fixed on a given direction Ĵdisc,out. We develop an iterative scheme based on ...

P. Frankovský, F. Trebuňa, Faculty of Mechanical Engineering, Technical University of Košice, Slovakia The presented article demonstrates the application of PhotoStress® method in stress analysis of a rotating disc of a constant thickness, which was made of a photoelastic material PS-1A. Isoclinic fringes were observed on the rotating disc using linear polarized light at revolutions 5 000 RPM. ...

Creep stresses and strain rates have been obtained for a thin rotating disc having variable density with inclusion by using Seth’s transition theory. The density of the disc is assumed to vary radially, i.e. ( ) 0 / m r b ρ ρ − = ; 0 ρ and m being real positive constants. It has been observed that a disc, whose density increases radially, rotates at higher angular speed, thus decreasing the pos...

Abstract Creep response for isotropic axisymmetric rotating disc made of a particle-reinforced FGM has been investigated in the present study. The result obtained for non linear variation of particle distribution along the radial distance of the disc are compared with that of discs containing the same amount of particle distributed uniformly or linearly along the radial distance. The disc under...

We consider the power of a relativistic jet accelerated by the magnetic field of an accretion disc. It is found that the power extracted from the disc is mainly determined by the field strength and configuration of the field far from the disc. Comparing with the power extracted from a rotating black hole, we find that the jet power extracted from a disc can dominate over that from the rotating ...