magnetite (fe 3 o 4  and nio) nanoparticles with a size range of 40–60 nm were prepared by sol-gel technique in nano and micro reverse micelles (water- in-oil). the surface properties, size, morphology and crystallographic structure of fe 3 o 4 and nio particles are characterized by means of x-ray diffraction, transmission electron microscope and scanning electron microscope which will give muc...

Two binary oxides, a spinel, ZnAl2O4, and a typical perovskite, LaMnO3, have been prepared via CTAB-1-butanol-n-octane-nitrate salt microemulsion in the reverse and bicontinuous states. The exact point of the reverse and bicontinuous states of the microemulsion used in the synthesis was determined by conductivity experiments. The materials obtained after heating at 800 degrees C were characteri...

copper sulfate was used as a precursor to prepare cuo nanoparticles in reverse micelles (o/w microemulsion).  this is a technique which allows the preparation of ultrafine metal oxide nanoparticles within the size ranging from 50 to 60 nm. the preparation of nano copper (ii) oxide studied was investigated in the inverse microemulsion system. therefore the nucleation of metal particles proceeds ...

The droplet phase of a reverse microemulsion formed by the surfactant cetyltrimethylammonium ferrocyanide was used as a matrix to synthesize nanoparticles of nickel hexacyanoferrate by adding just a solution of NiCl2 to the microemulsion media. Dynamic light scattering and small-angle neutron scattering measurements show that the reverse microemulsion droplets employed have a globular structure...

Acoustic spectroscopy was used to monitor the droplet size distribution in a classic three component system of heptane, water, and aerosol-OT (AOT). The size of the reverse microemulsion drops was varied by changing the molar ratio of water to AOT surfactant. The acoustic results for this transparent microemulsion were found to be in close agreement with literature results obtained with small a...

Lithium nickel oxide (LiNiO2) powders with an R3 m structure are successfully synthesized via a developed reverse microemulsion process. This method can effectively reduce the calcination temperature for synthesizing monophasic LiNiO2 powders to 700 C, which is much lower than that in the solid-state process. Nanosized LiNiO2 powders with narrow particle size distribution are obtained via the m...

In this work needle like hydroxy apatite were synthesized in a reverse microemulsion droplets of water in cyclohexane, separated by a cationic surfactant and co-surfactant, in the presence of Na-polyacrylate (PAA) as an anionic polyelectrolyte. Characterization of the as formed HAp nanoparticles at the room temperature were carried out by X-ray diffraction (XRD) and Fourier transform infrared s...

Polypyrrole (PPy) nanotubes have been fabricated by reverse microemulsion polymerization in an apolar solvent, and factors affecting the formation of PPy nanotubes have also been investigated.

Photochromic compound-conjugated fluorescent fullerene-silica nanoparticles prepared by the reverse-microemulsion method was utilized for photoswitchable cellular imaging by repeatable irradiation of ultraviolet and visible light.

Microemulsions are psuedohomogeneous mixtures which may show special performance towards reaction equilibria, nanoscale synthesis and reaction dynamics. Rate of reaction are most often accelerated in microemulsion media compared to that in water. This study is an effort to review some important reaction kinetics measured in reverse micro emulsion media. In the same time some pioneering research...