In this paper, a simple but effective method for compensation of the quadrature error in MEMS vibratory gyroscope is provided. The proposed method does not require any change in the sensor structure, or additional circuit in the feedback path. The mathematical relations of the proposed feedback readout system were analyzed and the proposed solution assures good rejection capabilities. Based on ...

A new CMOS current readout structure for the infrared (IR) focal-plane-array (FPA), called the buffered gate modulation input (BGMI) circuit, is proposed in this paper. Using the technique of unbalanced current mirror, the new BGMI circuit can achieve high charge sensitivity with adaptive current gain control and good immunity from threshold-voltage variations. Moreover, the readout dynamic ran...

This paper presents a frequency modulation based readout circuit for the measurement of skin conductance or resistance. A charge pump based frequency-to-voltage converter circuit with adjustable sensitivity is used to convert the frequency shifts due to skin resistance changes into voltage variations. The readout circuit improves the measurement accuracy and artifact rejection in measurements o...

Design and construction of a capacitor sensor with a precise readout system are described in this paper. A variable air-gap capacitive transducer was constructed and for signalmeasurement a successful attempt was made to exploit the capacitance changes in terms of the phase angle of the detected signal. The reported setup makes it possible to detect capacitance changes of the order of 2.5 fF in...

In this work the effects of uniaxial mechanical stress on a pixel readout circuit are theoretically analyzed. It is the effects of mechanical stress on the in-pixel transistors do not arise at the output, when a correlated double sampling circuit is used. However, mechanical stress effects on the photodiode will directly appear at the readout chain output. Therefore, compensation techniques are...

The voltage biased SQUID Bootstrap Circuit (SBC) was recently demonstrated for direct readout of SQUID signals. The SBC combines currentand voltage-feedbacks in one circuit to suppress the preamplifier noise. It offers not only a good noise performance, but also wide tolerance of SQUID parameters. Using SBC gradiometer, the bio-magnetic signals were successfully measured. In this paper, we over...

We present an alternative post-processing on a CMOS chip to release a planar microelectrode array (pMEA) integrated with its signal readout circuit, which can be used for monitoring the neuronal activity of vestibular ganglion neurons in newborn Wistar strain rats. This chip is fabricated through a 0.6 μm CMOS standard process and it has 12 pMEA through a 4 × 3 electrodes matrix. The alternativ...

This article describes the theory and design of an ultra-low noise electronic readout circuit for use with room temperature video-rate terahertz imaging arrays. First, the noise characteristics of various imaging detectors, including low resistance bolometers and high resistance diodes are discussed. Theoretical approaches to white and 1/f noise mitigation are examined, and a corresponding low-...

A monolithic resonance frequency readout circuit with high resolution and short measurement time is presented for a 900 MHz RF surface acoustic wave (SAW) sensor. The readout circuit is composed of a fractional-N phase-locked loop (PLL) as the stimulus source to the SAW device and a phase-based resonance frequency detecting circuit using successive approximation (SAR). A new resonance frequency...

This paper presents an energy-efficient readout circuit for resonant sensors that operates based on a transient measurement method. The resonant sensor is driven at a frequency close to its resonance frequency by an excitation source that can be intermittently disconnected, causing the sensor to oscillate at its resonance frequency with exponentially decaying amplitude. By counting the zero cro...