introduction radiofrequency planar microcoils are used to increase the resolution of magnetic resonance images of small samples. in this study, we aimed to design and fabricate a spiral planar microcoil constructed on a double-sided printed circuit board (pcb). it has four rings with an internal diameter of 241 microns tuned and matched at 63.8 mhz. materials and methods to achieve the maximum ...

Introduction Radiofrequency planar microcoils are used to increase the resolution of magnetic resonance images of small samples. In this study, we aimed to design and fabricate a spiral planar microcoil constructed on a double-sided printed circuit board (PCB). It has four rings with an internal diameter of 241 microns tuned and matched at 63.8 MHz. Materials and Methods To achieve the maximum ...

ABSTRACT The development of a cryo-cooling microfluidic device for reducing the resistive noise of a magnetic resonance (MR) microcoil to improve its signal-to-noise ratio (SNR) in MR microscopy applications is presented. The radiofrequency (RF) spiral coil was cryo-cooled to liquid nitrogen temperature (-196oC) by the integrated microfluidic channels carrying liquid nitrogen for decreasing the...

The predominant means to detect nuclear magnetic resonance (NMR) is to monitor the voltage induced in a radiofrequency coil by the precessing magnetization. To address the sensitivity of NMR for mass-limited samples it is worthwhile to miniaturize this detector coil. Although making smaller coils seems a trivial step, the challenges in the design of microcoil probeheads are to get the highest p...

The development of a microfluidically cryo-cooled and inductively coupled spiral microcoil for magnetic resonance (MR) microscopy with high signal-to-noise ratio (SNR) is presented. The microcoil was inductively coupled to a secondary coil that was directly coupled to a transmission line. This configuration eliminated thermal flux through direct connection when the microcoil was cryo-cooled to ...

Conventional chemical oxygen iodine lasers (COIL) offer several important advantages for materials processing, including short wavelength (1.3 μm) and high power. However, COIL lasers typically employ large hardware and use reactants relatively inefficiently. This project is creating an alternative approach called microCOIL. In microCOIL, most conventional components are replaced by a set of si...

This paper reports the fabrication of a novel microsensor structure using inductively coupled plasma source (ICP) dry etching process. The novel sensor is based on a SiO2/Si/SU-8 trilayered microcoil/microspring structure. The diameter of the microcoil was approximately 600 m. The ICP process and SU-8 exposing time are discussed. The SiO2 layer can be conveniently modified according to typical ...

We have developed two types of shape memory alloy (SMA) actuator and estimated the long-term reliability of SMA microcoils. A tube type tip articulator consists of 4 sets of SMA microcoil (wire diameter: 0.125 mm, coil diameter: 0.5 mm) for driving source and super elastic alloy (SEA) microcoils (wire diameter: 0.1 mm, coil diameter: 0.5 mm) for bias springs, support plates and flexible outer t...

This paper reports the fabrication and characterization of an adhesive-based liquid-metal microcoil for magnetic resonance relaxometry (MRR). Conventionally, microcoils are fabricated by various techniques such as electroplating, microcontact printing and focused ion beam milling. These techniques require considerable fabrication efforts and incur high cost. In this paper, we demonstrate a nove...

Recent advances in microtechnology allow realization of planar microcoils. These components are integrated in MEMS as magnetic sensor or actuator. In the latter case, it is necessary to maximize the effective magnetic field which is proportional to the current passing through the copper track and depends on the distance to the generation microcoil. The aim of this work was to determine the opti...