Wafer-scale arrays of well-ordered Pb(Zr(0.2)Ti(0.8))O3 nanodiscs and nanorings were fabricated on the entire area (10 mm x 10 mm) of the SrRuO3 bottom electrode on an SrTiO3 single-crystal substrate using the laser interference lithography (LIL) process combined with pulsed laser deposition. The shape and size of the nanostructures were controlled by the amount of PZT deposited through the pat...

In this report, ordered lead zirconate titanate Pb(Zr0.52Ti0.48)O3 (PZT) nanodot arrays were fabricated by an original one-step mask etching route. The one-step mask etching strategy is based on the patterned nanostructure of barrier layer (BL) at the bottom of anodic aluminum oxide (AAO), by a direct transfer of the nanopattern from BL to the pre-deposited PZT film, without introduction of any...

The evolution of nanostructure in sol-gel derived lead zirconate titanate (PZT) and zirconia precursor sols at different hydrolysis ratios was investigated by small angle X-ray scattering (SAXS). The shape of the clusters in the zirconia sol could be described by the length-polydisperse cylindrical form factor. The zirconia-based clusters were characterized by a cross-sectional radius, r(0), of...

Lead zirconate titanate (PZT) as a piezoelectric ceramic has been used widely in the fields of electronics, biomedical engineering, mechatronics and thermoelectric. Although, the electrical properties of PZT ceramics is a major considerable, but the mechanical properties such as fracture strength and toughness should be improved for many applications. In this study, lead monoxide, zirconium ...

Title of Document: BOTTOM-UP MULTIFERROIC NANOSTRUCTURES. Shenqiang Ren, Doctor of Philosophy, 2009 Directed By: Professor Manfred Wuttig Department of Materials Science and Engineering Multiferroic and especially magnetoelectric (ME) nanocomposites have received extensive attention due to their potential applications in spintronics, information storage and logic devices. The extrinsic ME coupl...

The Pb(Zr, Ti)O3 (PZT) based micro electro mechanical systems are presented. Piezoelectric effect, basic piezoelectric equations are explained. Lost silicon mold process for PZT microstructures, PZT thin film deposition, and PZT based piezoelectric micromachined switch device are discussed.

This study presents the analytical model and 3D simulation of piezoelectric square diaphragm pressure based on PZT-5H PZT-5A. The sensor's stress electrostatic are explained in sensor, all variables impacting induced output voltage covered. Piezoelectric materials such as PZT-5A, PZT-5J, PVDF, PMN-PT, LiNbO3, AlN, ZnO used to create sensors. COMSOL Multiphysics simulator simulates suggested sen...

Single crystalline PbZr(0.2)Ti(0.8) (PZT) nanowires arrays (NWAs) with taper morphology were epitaxially grown on SrTiO(3) (STO) substrate using pulse laser deposition. The taper morphology was attributed to the overcoating of PZT layer via a lateral growth of PZT clusters/adatoms during PZT NW growth. The growth window for PZT film or nanowire was systematically studied at varied temperatures ...

In this work, after investigating three typical magneto-electric (ME) composites, Permendur/Pb(Zr0.52Ti0.48)O3(PZT), Metglas/PZT, and Tefenol-D/PZT, with the same dimensions and different saturation magnetostriction and magnetic permeability, the most excellent ME performance is observed in the Permendur/PZT laminates, which agrees well with the predicted results from the figure of merit. The l...