Various methods have been presented to improve the performance of buildings against earthquakes. Friction damper device is one of the energy dissipation devices that appropriately absorbs and dissipates the input energy and decreases displacements. In this paper, the possibility of using endurance time method to determine the efficiency index and optimum slip load for these dampers was investig...

Most of oil and gas offshore platforms are located in the seismic regains. So, Seismic vulnerability evaluation of the offshore platforms is one of the most important and vital issues in the structural systems. In this study, jacket type offshore platforms are studied by incorporating the pushover analyses and nonlinear time history analyses, in such a way that, first some push over analyses ar...

endurance time (et) method is a relatively new performance-based earthquake method for structural evaluation and design. in this method, the structure is subjected to a gradually intensifying accelorogram(s) and its performance is assessed based on the maximum time duration that it can meet the specified performance objectives. using moment-resisting and braced frames which are rehabilitated by...

 Many existing bridges were designed without adequate consideration of seismic risk. The full or partial collapse of even one major bridge in a city or community would have destroying results. There has been focuses on developing fragility-based seismic vulnerability of existing usual bridges in Iran or support decision making on seismic upgrade. This article focuses on developing performance b...

Endurance time (ET) method is a relatively new performance-based earthquake method for structural evaluation and design. In this method, the structure is subjected to a gradually intensifying accelorogram(s) and its performance is assessed based on the maximum time duration that it can meet the specified performance objectives. Using moment-resisting and braced frames which are rehabilitated by...

the purpose of this study is to determine the effect of vierendeel panel width and vertical truss spacing ratio in an inelastic behavior of the stf system due to earthquake loads. the stf system is applied to a six-storey building that serves as apartments [2]. the stf system is used in the building in the transverse direction (n-s direction), while in the longitudinal direction (w-e direction)...

In the present paper, nonlinear behavior of mass concrete simulated by smeared crack model is combined with Endurance Time Analysis (ETA) method for studying seismic response of arch dams. ETA is a time-history based dynamic pushover procedure in which special predesigned intensifying acceleration functions are used for analysis and estimation of structural responses in various performance leve...

The base isolation systems are among the passive control devices that have been used over the last three decades to limit the seismic-induced response of structures. In this regard, the Uniform Building Code provisions (UBC) has incorporated a special section for the seismic design of base isolated structures since its 1991 edition. Due to the importance of the behavior of these structures unde...

The base isolation systems are among the passive control devices that have been used over the last three decades to limit the seismic-induced response of structures. In this regard, the Uniform Building Code provisions (UBC) has incorporated a special section for the seismic design of base isolated structures since its 1991 edition. Due to the importance of the behavior of these structures unde...

response modification factor (r factor) is one of the seismic design parameters to be considered in evaluating the performance of buildings during strong motions. this paper has tried to evaluate the response modification factor of concrete coupled shear wall structures with various length/depth ratios of spandrel beams. the effect of diagonal reinforcement of spandrel beam was also evaluated o...