objective: in this article, a numerical study is conducted on mixing of two fluids in the liquid phase with two different concentrations of a chemical species in the electro-osmotic flow. methods: the base liquid is an electrolyte which flows in a two-dimensional micro-channel having electrically charged walls. lorentz electric force, which is used as stimulating flow factor, is created by appl...

We have developed a novel micro-mixer using a biological molecular ATP motor. The micro-mixer was constructed from arrays of chromatophore-embedded delta-free F(0)F(1)-ATPases, where the delta-free F(1) part acted as a rotator to mix solutions, and the F(0) part was driven by light. Confocal microscope studies indicated that the micro-mixer did not touch directly on the fibrin labeled with FITC...

BACKGROUND Fatty acid composition is an important physiological parameter of microalgae, which is taken as the third generation alternative resource of biodiesel. To boost microalgal research and applications, a convenient, rapid, and acid-catalyzed transesterification procedure that satisfies the demand for the analysis of the fatty acid composition of lipids with micro-scale samples in the hi...

in this paper the influence of two different sizes of silica particles (micro-silica and nano-silica) was studied on mechanical properties of sulfur and sulfur composite. to improve the structural properties, sulfur was plasticized using dicyclopentadiene (dcpd) and methyl styrene (mst). plasticized sulfur composite was prepared by melt blending of plasticized sulfur and silica particles. the i...

In this paper, we study the Lyapunov exponents of a micro chaotic mixer to understand the mixing effectiveness under different operating parameters. A simple kinematic micro mixer model is used for the simulated flow visualization and then for the computation of Lyapunov exponents using two different numerical methods. These two methods generate consistent result to corroborate the existence of...

9 The effect of mixer shear strain rate on the performance of a model 10 micro-crystalline cellulose pharmaceutical paste undergoing extru11 sion–spheronisation was studied using a laboratory scale planetary 12 mixer and a screw-based mixer. The maximum shear strain rate in 13 each mixer was estimated. Five pastes were prepared, one each at 14 97 and 265 s−1 in the planetary mixer, and one each...

The liquid streams in a microchannel are hardly mixed to form laminar flow, and the mixing issue is well described by a low Reynolds number scheme. The staggered herringbone mixer (SHM) using repeated patterns of grooves in the microchannel have been proved to be an efficient passive micro-mixer. However, only a negative pattern of the staggered herringbone mixer has been used so far after it w...

In this paper, we proposed a novel bonding technology to fabricate a microfluidic device based on Poly(methyl methacrylate) (PMMA). The method, which used chloroform and ethanol as miscible bonding solvent, can complete complex structures rapid assembly (10 min) at 40°C. A bonding strength of 267.5 N/cm2 can be achieved, while the micro channel deformation was less than 7.26%. Then we utilized ...

The degree of mixing of a T-shaped micro-mixer depends strongly on the inlet flow conditions. Specifically, through a series of numerical simulations, we compared the case where the flow at the micro-mixer confluence is fully developed with that when it is not, and found that in the former case engulfment occurs at smaller Reynolds number, with a different flow pattern and with much larger mixi...

The mixing of Newtonian and non-Newtonian fluids in a magnetic micro-mixer was studied numerically using  ferrofluid. The mixing process was performed in a three-dimensional steady-state micro-mixer. A magnetic source was mounted at the entrance of the micro-channel to oscillate the magnetic particles. The effects of electric current, inlet velocity, size of magnetic particles, and non-Newtonia...