The rapidly solidified prealloyed alpha brass powder with a size range of 40 to 100 μm produced by water atomization process was consolidated using liquid phase sintering process. The relationships between sintering temperature, physic-mechanical properties and microstructural characteristics were investigated. Maximum densification was obtained at 930 °C, under 600 MPa compacting pressure,...

Prealloyed powders usually melt over a range of temperatures. This feature is useful in performing supersolidus liquid phase sintering, where liquid forms inside the particles when heated just over the solidus temperature. Densification by supersolidus liquid phase sintering is sensitive to time-temperatures. A major difficulty arises when a narrow temperature range exists between densification...

This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....

The effective shear and bulk viscosity, as well as dynamic viscosity, describe the rheological properties of the ceramic body during the liquid phase sintering process. The rheological parameters depend on the physical and thermo-mechanical characteristics of the material such as relative density, temperature, grain size, diffusion coefficient, and activation energy. Thermal behavior of the cer...

The rearrangement process during liquid phase sintering has been generally accepted that driven by the capillary forces between solid grains embedded in liquid. This paper outlines a computer-based method for three-dimensional computer simulation of rearrangement during liquid phase sintering. The theoretical models dealing with the fundamental interaction forces that exist between grains attac...

A two-dimensional method based on basic and mixed models for simulation of liquid phase sintering of a porous structure will be developed. These models will be tested in order to conduct a study of diffusion phenomena and gravitational effects on microstructural evolution during liquid phase sintering of a W-Ni system.

A two-stage sintering practice was applied to W­3.99Ni­1.71Fe (mass%) to control its microstructural evolution and, accordingly, mechanical properties under high strain rates. Unlike the traditional one-stage liquid phase sintering, the alloy was first solid-state-sintered to close to full densification, and then liquid-phase-sintered by induction heating where the cooling rate was fast. With t...

In this paper, we investigated numerically gravity induced skeletal settling during liquid phase sintering. The microstructural evolution will be simulated by simultaneous computation of displacement of the center of mass and mass transport due to dissolution and precipitation at the interfaces between solid-phase and liquid matrix. Common to this study based on domain methodology for definitio...

Polycrystalline samples of Lead free (K0.5Na0.5)1−x(Li)x(Sb)x(Nb)1−xO3 ceramics with nominal compositions (x = 0.040 to 0.060) have been prepared by high temperature solid state reaction technique. X-ray diffraction (XRD) pattern shows that the crystal structure transforms from orthorhombic to tetragonal as Li and Sb content increases. Normal sintering process yield compounds with density ~98.2...