Background: Laminar flow ventilation systems were developed to reduce surgical contamination in joint arthroplastyto avoid periprosthetic joint infection (PJI). The goals of this study are to evaluate the cost-effectiveness and economicviability of installing and maintaining a laminar flow system in an operating room.Methods: A Monte Carlo simulation was used to evaluate the c...

in the present work, an engineering method is developed to predict laminar and turbulent heating-rate solutions for blunt reentry spacecraft at hypersonic conditions. the calculation of aerodynamic heating around blunt bodies requires alternative solution of inviscid flow field around the hypersonic bodies. in this paper, the procedure is of an inverse nature, that is, a shock wave is assumed a...

the flow of fluids in annular conduits has been studied for over sixty years, however the resulted data are very scattered. in this paper the problem is analytically solved, starting out with navier-stokes equations. a computer solution is used to determine the shape of velocity profiles, the discharge and the friction factor in a large number of concentric and eccentric annular conduits. the e...

We have demonstrated the efficacy of a microfluidic medium exchange method for single cells using passive centrifugal force of a rotating microfluidic-chip based platform. At the boundary of two laminar flows at the gathering area of two microfluidic pathways in a Y-shape, the cells were successfully transported from one laminar flow to the other, without mixing the two microfluidic mediums of ...

in this paper, the flow around bluff bodies with different cross sections and determination of forces acts on them are investigated.this paper presents the results of a numerical study on the flow characteristics and heat transfer over two equal square cylinders in a tandem arrangement. spacing between the cylinders is 5 widths of the cylinder and the reynolds number ranges from 1 to 200, pr=0....

in order to examine the laminar convective heat transfer of nanofluid, experiments carried out using silver-oil nanofluid in a concentric annulus with outer constant heat flux as boundary condition. silver-oil nanofluid prepared by electrical explosion of wire technique and observed no nanoparticles agglomeration during nanofluid preparation process and carried out experiments. the average size...

An autoradiographic method (14C-iodoantipyrine autoradiography) was used to measure regional optic nerve blood flow (ONBF) under basal conditions in 11 adult female cats. Flow was measured in six regions of the optic nerve: (1) prelaminar, (2) laminar, (3) 1 mm post-laminar, (4) 4 mm post-laminar, (5) 6 mm post-laminar, and (6) intracranial optic nerve and chiasm. A gradient of flow rates was f...

mixed convection is a fundamentally significant heat transfer mechanism that occurs in selection industrial and technological applications. in this study, first the laminar mixed convection inside rectangular enclosure with moving wall and aspect ratio=10 is modeled and then the results are compared with other investigate. after showing varity of results, the investigation is continued with tur...

Tobacco smoking and hemodynamic forces are key stimuli in the development of endothelial dysfunction and atherosclerosis. High laminar flow has an atheroprotective effect on the endothelium and leads to a reduced response of endothelial cells to cardiovascular risk factors compared to regions with disturbed or low laminar flow. We hypothesize that the atheroprotective effect of high laminar flo...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...