Thin 1 mm or 1.5 mm Kirschners wires which as suitable for paediatric or adult hand bones have 3 sharpened end facets. The mini-Ilizarov fixator is composed of fixation units (Figure 1) for attaching the wires in to the slots (7) of slotted washers (3) and their fastening with a fixation nut (8) (Figure 2). (A) composed of slotted washers (3,7), space washer (4), bolt (5) with an axial hole and...

Single staggered is a design development of normal wire and tube heat exchanger that wires are welded with staggered configuration on two sides. Capacity of wire and tube heat exchanger is the ability of the heat exchanger to release heat. The objective of this study is to analyse the effect of wire pitch (pw) on capacity of single staggered wire and tube heat exchanger. The research...

at the final stages of a coronary artery bypass graft operation on a 64-year-old man, an experienced physician attempted to insert an intra-aortic balloon pump into the femoral artery via the seldinger technique. however, while the balloon pump was being passed over the guide wire, the latter was completely lost. the guide wire should be held at the tip at all times to prevent passage into the ...

the effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. in this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. the results were the minimum interlamellar spacing of 35 nm and maximum ulti...

the micro wire electrical discharge machining (micro wire-edm) process is a modern machining process with various applications in manufacturing micro-parts. the recast layer remaining on the machined surfaces is an inevitable complication of this process. this layer can subsequently affect the machined parts performance. to optimize the recast layer in the micro wire-edm of the molybdenum micro...

The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...

The effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. In this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. The results were the minimum interlamellar spacing of 35 nm and maximum ulti...

in this study, as for the re-casting, surface alloying and re-solidification layer of this alloys at the work piece level machining with wire electro discharge machining (wedm), changes of surface micro hardness with changes of operational parameters has been studied. therefore, study shows using surface alloying phenomena with the diffusion of wire material into the machined surface and select...

objective: corrosion resistance is among the most important properties of metal alloys used in the oral cavity. consumption of acidic foods reduces the salivary ph and intensifies the corrosion of brackets and orthodontic wires. this study aimed to compare electro galvanic corrosion of different orthodontic brackets and wires and determine the amount of ions released into acidic artificial sali...

central venous catheterization (cvc) is a commonly performed procedure for venous access. it is associated with several complications. we report a rare case of extra luminal entrapment of guide wire during cvc placement in right jugular vein. we report a case of 28 years old female patient presented in our emergency with history of entrapped guide wire in right side of neck during cvc. x-ray sh...