The objective of this paper is to present novel control strategies for MicroGrid operation, especially in islanded mode. The control strategies involve mainly the coordination of secondary load-frequency control by a MicroGrid Central Controller that heads a hierarchical control system able to assure stable and secure operation when the islanding of the MicroGrid occurs and in load-following si...

After microgrid transition from the normal operation to the islanded operation the system impedance changes considerably and it affects on the harmonic voltages of the microgrid. In this paper the voltage and current THD before and after islanding are studied with different microgrid configurations. Simulations are also made by applying negative sequence filtering in control system of converter...

modeling and simulation of flywheel energy storage system as v/f reference in islanded microgrid

As usual, the microgrid operates in grid-connect mode, but, when a fault occurs in the upstream grid, it should disconnect and shift into islanded operation mode. In grid-connect mode, the controlling power at the PCC is necessary management function rather than the frequency and voltage. However, the controlling the frequency and voltage is asked in islanded mode. To achieve these management g...

The issue of frequency stability of microgrids under islanded operation mode and mode transfer has attracted particular attention recently. In this paper, a cooperative frequency control method, which consists of a microgrid central control (MGCC) and microgrid local control (MGLC), is proposed to achieve a seamless transfer from grid-connected to islanded mode, and hence increase the frequency...

Conventional droop control is a basic control strategy for power sharing in islanded microgrid applications. This strategy has several limitations, such as low transient response, frequency and voltage deviations. This paper presents a modified droop control method for the proper operation of parallel-connected inverters in islanded microgrid. The proposed method is able to improve transient re...

One of the most important requirements of microgrid operation is to maintain a constant frequency such as 50 Hz or 60 Hz, which is closely related to a power balance between supply and demand. In general, microgrids are connected to power grids and surplus/shortage power of microgrids is traded with power grids. Since islanded microgrids are isolated from any power grids, the decrease in genera...

Because of their small scale and large share of intermittent power sources, islanded microgrids require additional means of flexibility, such as dedicated storage. For controlling the loads and distributed generation (DG) units in an islanded microgrid, the voltage-based droop (VBD) control has been developed. This controller determines the switching actions of these units’ power electronic int...

This paper proposes a new distributed control architecture for distributed generation units in heterogeneous DC islanded microgrids. Each unit is equipped with state-feedback baseline and augmenting L1 adaptive voltage controllers at the primary level of the microgrid control hierarchy. Local controller synthesis is scalable as it only requires information about corresponding units, couplings, ...

A microgrid is composed of distributed power generation systems (DGs), distributed energy storage devices (DSs), and loads. To maintain a specific frequency in the islanded mode as an important requirement, the control of DGs' output and charge action of DSs are used in supply surplus conditions and load-shedding and discharge action of DSs are used in supply shortage conditions. Recently, mult...