in this paper, the interface crack of two non-homogenous functionally graded materials is studied. subsequently, with employing the displacement method for fracture of mixed-mode stress intensity factors, the continuous variation of material properties are calculated. in this investigation, the displacements are derived with employing of the functional graded material programming and analysis o...

In this paper, the interface crack of two non-homogenous functionally graded materials is studied. Subsequently, with employing the displacement method for fracture of mixed-mode stress intensity factors, the continuous variation of material properties are calculated. In this investigation, the displacements are derived with employing of the functional graded material programming and analysis o...

the nonlinear discrete crack modeling of Shahid Rajaee thin arch dam is considered. The interface elements are positioned such that certain potential separated blocks can form possible failure mechanisms. The dynamic stability of theses blocks are investigated by a special finite element program "MAP-73" which its nonlinear algorithm and interface elements formulation are presented.

We investigate the roughening of shear cracks running along the interface between a thin film and a rigid substrate. We demonstrate that short-range correlated fluctuations of the interface strength lead to self-affine roughening of the crack front as the driving force (the applied shear stress/stress intensity factor) increases towards a critical value. We investigate the disorder-induced pert...

This paper presents the simple method to determine the complex stress intensity factor of interface crack problem by the finite element method. The proportional method is extended to the interface crack problem. In the present method, the stress values at the crack tip calculated by FEM are used and the stress intensity factors of interface crack are evaluated from the ratio of stress values be...

The experimental determination of fracture mechanical properties of interface cracks is a substantial task for the design for reliability of electronic packages. As interface cracks are dominated by a mode mix between tension and shear mode (crack driving modes I and II) a mixed mode bending method was developed to adjust the ratio of the two modes (mode mixity). For a correct extraction of an ...

OBJECTIVES The objective of this in vitro study was to evaluate the fatigue crack growth properties of the dentin/resin adhesive interface. METHODS Compact tension (CT) specimens were prepared from coronal dentin, resin composite, and dentin bonded to resin composite using Optibond Solo Plus adhesive. All specimens were then subjected to cyclic Mode I loading while fully hydrated at a stress ...

Modelling quasi-static crack growth with interface elements is a widely accepted technique [1-2]. Interface elements are inserted into the finite element mesh along possible crack paths. The interface elements are characterised by a traction-displacement curve. When a specific maximum stress is reached, the interface element undergoes a softening process until the critical fracture energy has b...

Delamination of residually stressed thin film strips is analyzed to expose the dependence on strip width and filmysubstrate elastic mismatch. Isotropic films and substrates are assumed. The residual stress in the film is tensile and assumed to originate from mismatch due to thermal expansion or epitaxial deposition. Full and partial delamination modes are explored. In full delamination, the int...

Nowadays total joint replacements are widely used in the world, so in average 800,000 joint surgeries are done yearly only in Europe and North America. However implant loosening is and remains as the major issue of all implant failures and therefore causes revision surgery procedures. Studies and experiments have identified poor fixation of implants most likely is the main cause of long term im...