نتایج جستجو برای: Injection temperature
تعداد نتایج: 603224 فیلتر نتایج به سال:
a semi-empirical mathematical model for predicting physical part of ignition delay period in the combustion of direct - injection diesel engines with swirl is developed . this model based on a single droplet evaporation model . the governing equations , namely , equations of droplet motion , heat and mass transfer were solved simultaneously using a rung-kutta step by step unmerical method . the...
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
in this work, a novel and fast method for direct analysis of volatile compounds (davc) of medicinal plants has been developed by holding a filament from different parts of a plant in the gc injection port. the extraction and analysis of volatile components of a small amount of plant were carried out in one-step without any sample preparation. after optimization of temperature, extraction time a...
injection molding is one of the most common processes which are used for manufacturing different plastic parts. this method includes 3 continuous steps: filling of the mold, cooling and driving the part out. a wide range of plastic and non-plastic materials can be used as raw material in this process. one of the most important advantages of this way of production is that it is very economic. in...
according to the temperature distribution of water injection well-bore in highly deviated wells under different conditions and unstable temperature field heat conduction principles, a true three-dimensional model was established to analyze the law of variation on temperature of highly deviated wells during the water injection process, and to analyze the factors that influence the water injectio...
the effect of intracerebroventricular injections of prostaglandins e2 and f2a was studied on the rectal temperature of sheep. pge2 but not pgf2a at the same dose of 50mg elevated the 1h post-injection of rectal temperature. pge2 but not pgf2a at the same dose of 100mg increased 3.5 and 2h post-injection of rectal temperature, respectively. elavation of rectal temperature following pge2 and pgf2...
چکیده ندارد.
According to the temperature distribution of water injection well-bore in highly deviated wells under different conditions and unstable temperature field heat conduction principles, a true three-dimensional model was established to analyze the law of variation on temperature of highly deviated wells during the water injection process, and to analyze the factors that influence the water injectio...
in the continuous gas lift operation, compressed gas is injected into the lower section of tubing through annulus. the produced liquid flow rate is a function of gas injection rate and injection depth. all the equations to determine depth of injection assumes constant density for gas based on an average temperature of surface and bottomhole that decreases the accuracy of gas lift design. also g...
Plastic injection is a method in which, with using an extruder in granules, plastic is injected in a hole with high pressure. Because of meeting the two flow fronts in this process welding line will be made. Along the welding line the strength of produced part is low; therefore the position of welding line and its clarity are very important. In this paper, analyzes have been done with Fluent an...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید