injection molding is one of the most important and common plastic formation methods. combination of modeling tools and optimization algorithms can be used in order to determine optimum process conditions for the injection molding of a special part. because of the complication of the injection molding process and multiplicity of parameters and their interactive effects on one another, analytical...

This paper presents measurements of acoustic emission (AE) signals during the injection molding of polypropylene with new and damaged mold. The damaged injection mold has cracks induced by laser surface heat treatment. Standard test specimens were injection molded, commonly used for examining the shrinkage behavior of various thermoplastic materials. The measured AE burst signals during injecti...

for 2006 IEEE 1 An Environmental Analysis of Injection Molding Extended Abstract – Green Manufacturing Processes Alexandre Thiriez and Timothy Gutowski Department of Mechanical Engineering Massachusetts Institute of Technology Rm. 35-234 77 Massachusetts Ave. Cambridge, MA 02139 Plastic components are integral parts in electrical and electronic (E&E) products. 8.5% of the plastic production is ...

background and aims. the aim of this study was to compare flexural strength of specimens processed by conventional and injection-molding techniques. materials and methods. conventional pressure-packed pmma was used for conventional pressure-packed and injection-molded pmma was used for injection-molding techniques. after processing, 15 specimens were stored in distilled water at room temperatur...

During the recent years powder processing technologies have gained much attention due to the less energy consumption and recyclable powders. Manufacturing of complicated parts by the conventional powder metallurgy (PM) method is hard due to the uniaxial pressure, which leads to the low design flexibility. In order to prevail these constraints, powder injection molding (PIM) process, which inclu...

http://www.journal-imab-bg.org / J of IMAB. 2016, vol. 22, issue 3/ ABSTRACT Purpose: The purpose of this in vivo study is to register the forces necessary to displace maxillary complete dentures fabricated by compression molding and injection molding techniques on one and the same patient and to compare the interfacial surface tension and capillarity which are achieved by both techniques. Mate...

acrylic resin denture bases undergo dimensional changes during polymerization. injection molding techniques are reported to reduce these changes and thereby improve physical properties of denture bases. the aim of this study was to compare dimensional changes of specimens processed by conventional and injection-molding techniques.sr-ivocap triplex hot resin was used for conventional pressure-pa...

Gas-assisted injection molding process is much complicated,the process parameters have multiplied. In this paper, a product with typical character of gas-assisted injection molded part is employed as the object of study. With the mould of gas-assisted injection molding and MPI/3D GAS in Moldflow software,the influence rule of the 6 important process parameters on gas penetration length in gas-a...