The objective of this study was to examine the effects of the hydroxyapatite (HA) reinforcement morphology and content on the fatigue behavior of HA reinforced high density polyethylene (HDPE). To this end, HDPE was reinforced with 20 and 40 vol% of either HA whiskers or an equiaxed HA powder, and tested in four-point bending fatigue under simulated physiological conditions. The fatigue life, m...

In the process of polyethylene extrusion polymer material similar to powder or granule is under compression, melting and transmission operation and on base of special form, extrudate has been produced. Twin-screw extruders are applicable in industries because of their high capacity. The powder mixing with chemical additives and melting with thermal and mechanical energy in three zones (feed, co...

Plasma treatment of particles offers to tailor macroscopic powder properties like wettability, flowability or compactibility. Plasma activation normally leads to an enhanced wettability and the deposition of SiOx-like nanostructures on the substrate particle surface increases the flowability and compactibility. These different functionalities are investigated and compared for the polymer HDPE (...

Synthetic hydroxyapatite (HA) whiskers have been utilized as a new, biocompatible reinforcement for orthopedic biomaterials. High-density polyethylene (HDPE) was reinforced with either the synthesized HA whiskers or a commercially available spherical HA powder using a novel powder processing technique that facilitated uniform dispersion of the reinforcements in the matrix prior to compression m...

Studies have proved that increasing polymer matrices by carbon nanotubes to form structural reinforcement and electrical conductivity have significantly improved mechanical and electrical properties at very low carbon nanotubes loading. In other words, increasing polymer matrices by carbon nanotubes to form structural reinforcement can reduce friction coefficient and enhance anti-wear property....

In the current work, high density polyethylene (HDPE) composites were fabricated via Friction Stir Processing (FSP). A two-phase Fe-Fe3O4 powder was used as reinforcing agents. The extremely low cost obtained from shot-blasting of as-forged carbon steel components. X-ray diffraction (XRD) to phase analysis and evaluation purity as-received powder. size distribution determined by Laser Particle ...

The use of wood-derived fillers by the thermoplastic industry has been growing, fueled in part by the use of wood-fiber– thermoplastic composites by the construction industry. As a result, the durability of wood-fiber–thermoplastic composites after ultraviolet exposure has become a concern. Samples of 100% high-density polyethylene (HDPE) and HDPE filled with 50% woodflour (WF) were weathered i...

Thermal behaviors of eucalyptus wood residue (EWR) filled recycled high density polyethylene (HDPE) composites have been measured applying the thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). Morphology of the materials was also studied using scanning electron microscope (SEM). Addition of the EWR into the recycled HDPE matrix reduced the starting of degradation tem...

This study proposes melt-blending polypropylene (PP) and high density polyethylene (HDPE) that have a similar melt flow index (MFI) to form PP/HDPE polyblends. The influence of the content of HDPE on the properties and compatibility of polyblends is examined by using a tensile test, flexural test, Izod impact test, scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTI...