The design and optimization of nanostructure-based surface acoustic wave (SAW) gas sensor is analyzed based on TiO2 sensing layer and modified electrode dimensions. The sensitivity of the gas sensor depends upon the type of sensing layer used and active surface area obtained by varying the aspect ratio. The performance of the sensor is observed from 0.1ppm to 100ppm concentration of ...

Semiconductor oxide chemoresistive gas sensors are widely used for detecting deleterious gases due to low cost, simple preparation, rapid response and high sensitivity. The performance of gas sensor is greatly affected by the morphology of the semiconductor oxide. There are many semiconductor oxide morphologies, including zero-dimensional, one-dimensional, two-dimensional and three-dimensional ...

The high crystallinity ZnO nanoparticles with an average particle diameter 30 nm have been successfully synthesized with a surfactant-mediated method. The cationic surfactant (cetyltrimethylammonium bromide, CTAB) and the hydrous metal chlorides (ZnCl2⋅2H2O) appear to be the good candidates for obtaining a high yield of nanoparticles. The structural and morphological characterizations were carr...

Gas sensors based on titanium dioxide (TiO₂) have attracted much public attention during the past decades due to their excellent potential for applications in environmental pollution remediation, transportation industries, personal safety, biology, and medicine. Numerous efforts have therefore been devoted to improving the sensing performance of TiO₂. In those effects, the construct of nanohete...

Sensing technology has been widely investigated and utilized for gas detection. Due to the different applicability and inherent limitations of different gas sensing technologies, researchers have been working on different scenarios with enhanced gas sensor calibration. This paper reviews the descriptions, evaluation, comparison and recent developments in existing gas sensing technologies. A cla...

This review focuses on polymer field-effect transistor (PFET) based gas sensor with polymer as the sensing layer, which interacts with gas analyte and thus induces the change of source-drain current (ΔISD). Dependent on the sensing layer which can be semiconducting polymer, dielectric layer or conducting polymer gate, the PFET sensors can be subdivided into three types. For each type of sensor,...

Systematic development and mechanistic studies of sensing materials are critical to the design of higher performance gas sensing elements and arrays. Polycrystalline metal-oxide semiconductors such as SnO2 and TiO2 are among the most widely used materials for thin film-based conductometric gas sensors. The mechanistic steps responsible for the gas-induced conductance changes of polycrystalline ...

The influence of the Ar/O2 gas ratio during radio frequency (RF) sputtering of the RuO2 sensing electrode on the pH sensing performance is investigated. The developed pH sensor consists in an RF sputtered ruthenium oxide thin-film sensing electrode, in conjunction with an electroplated Ag/AgCl reference electrode. The performance and characterization of the developed pH sensors in terms of sens...

We report the nanostructures and gas-sensing properties of Zinc oxide nanosheets prepared by hydrothermal method. In particular, needlelike Zinc oxide was also prepared for comparison. The morphology and structural properties were investigated using X-ray diffraction (XRD), scanning electron microscope (SEM) and transmission electron microscope (TEM). Subsequent gas-sensing measurement between ...

SnO2 nanobelts (NBs) have unique structural and functional properties which attract great attention in gas detecting. In this work, Eu doping is adopted to improve the gas sensitivity of pure SnO2, especially to enhance the response to one single gas. The Eu-doped SnO2 NBs, pure-SnO2 NBs, and their single NB devices are fabricated by simple techniques. The sensing properties of the two sensors ...