Two phase gas-liquid flow pattern in a horizontal pipeline is predicted very accurately using a newly-developed analytical relation. The pattern identification is based on one of the most widely used graphs, the Baker diagram, modified in a way that compensates for the unrealistic oversimplifications of recent works. The Kern's method of pressure drop calculation is used to obtain the frict...

In the present paper the pressure drop characteristics of a 1.4 mm hydraulic diameter multiport minichannel tube during adiabatic two-phase flow of HFC refrigerants are discussed. The tube consists of eleven parallel rectangular cross section channels. Although much experimental research has been devoted to investigate the pressure drop characteristics of R134a inside multiport minichannels in ...

Two-phase frictional pressure drop data were obtained for condensation of carbon dioxide in single horizontal micro tube of inner diameter ranged from 0.6 mm up to 1.6 mm over mass flow rates from 2.5*10 to 17*10 kg/s and vapor qualities from 0.0 to 1.0. The inlet condensing pressure is changed from 33.5 to 45 bars. The saturation temperature ranged from -1.5 C up to 10 C. These data have then ...

The pressure drop of single phase was studied experimentally with non-Newtonian fluids of Carboxy Methyl Cellulose (CMC). Single helical coil with five different helix angles were used in this study to identify the effect of helix angle on pressure drop. The effect of helix angle is significant in moderate and high generalized Dean’s number of laminar region. The effect is insignificant in low ...

A new theoretical method for computing travel distance, number of turns, and cyclone pressure drop has been developed and is presented in this article. The flow pattern and cyclone dimensions determine the travel distance in a cyclone. The effective number of turns was calculated based on the travel distance. Cyclone pressure drop is composed of five pressure loss components. The frictional pre...

0894-1777/$ see front matter 2010 Elsevier Inc. A doi:10.1016/j.expthermflusci.2010.12.007 ⇑ Corresponding author. Tel.: +91 44 2257 4154. E-mail address: [email protected] (A.R. Balakrishna The effect of tube diameter on two-phase frictional pressure drop was investigated in circular tubes with inner diameters of 0.6, 1.2, 1.7, 2.6 and 3.4 mm using air and water. The gas and liquid superficial...

In the present study, the flow boiling heat transfer of R1234ze(E), R32 and zeotropic mixture R1234ze(E)/R32 (50/50 mass%) in a horizontal micro-fin tube is experimentally investigated to clarify the pressure drop and heat transfer characteristics. Tested micro-fin tube is made of copper, and its geometry is as follows, 6.00 mm in outer diameter, 5.21 mm in mean inside diameter, 0.26 mm in fin ...

In designing of condensers, the prediction of pressure drop is as important as the prediction of heat transfer coefficient. Modeling of two phase flow, particularly liquid – vapor flow under diabatic conditions inside a horizontal tube using CFD analysis is difficult with the available two phase models in FLUENT due to continuously changing flow patterns. In the present analysis, CFD analysis o...