s Some zirconia foams are used as heating elemeht in electrical furnaces. Their creep behaviour has been investigated at high temperature and under low stress. Important visco-elastic behaviour has been observed. It is likely due to recrystallization, which is sensitive to the tetragonal-cubic phase transition and to the stress. I INTRODUCTION Porous and dense zirconia based ceramics have been ...

conventional and nanostructured ysz coatings were deposited on the in-738 ni super alloy by the atmospheric plasma spray technique. the oxidation was measured at 1100°c in an atmospheric electrical furnace. according to the experimental results the nanostructured coatings showed a better oxidation resistance than the conventional ones. the improved oxidation resistance of the nanocoating could ...

Conventional and nanostructured YSZ coatings were deposited on the IN-738 Ni super alloy by the atmospheric plasma spray technique. The oxidation was measured at 1100°C in an atmospheric electrical furnace. According to the experimental results the nanostructured coatings showed a better oxidation resistance than the conventional ones. The improved oxidation resistance of the nanocoating could ...

In this research, modeling, simulation, and control of a methanol-to-olefins laboratory fixed-bed reactor with electrical resistance furnace have been investigated in both steady-state and dynamic conditions. The reactor was modeled as a one-dimensional pseudo-homogeneous system. Then, the reactor was simulated at steady-state conditions and the effect of different parameters including...

air cooled blast furnace slag is a by product made of gradually air cooled molten blast furnace slag, and is often stored in stockpiles near the iron mills and usually occupy a wide area around the iron mills. from this perspective the further use of these materials can have its own merits. air cooled blast furnace slag can be used in asphalt mixtures because of their proper frictional properti...

Magnesium-Aluminum alloys considered specially Mg-6Al very important in engineering applications, but this have weakly wear resistance and low hardness, therefore, addition some materials such as (Al2O3) at (3%-4%-5%) weight percentage to improve the hardness resistance. In present research was prepare a master alloy then recast after adding under argon gas electrical furnace, study effect of o...

steel industry is one of the most consumption of energy in the world, which is related to melting furnace which result environmental pollution. we calculate the energy consumption and capital cost of dust collectors of venturi scrubber (vs) and electrostatic precipitator (esp) which are connected to melting furnace in respect to industrial ecology for selection of appropriate dust collection sy...

Ferrochrome is the major chromium source for stainless steel production, and submerged-arc furnaces (SAF) are most commonly utilised to smelt chromite ores into ferrochrome by using suitable carbonaceous reductants such as coke. Because of the complexity of feed structure and electrical-thermal-chemical interactions, there exist large gradients and wide distributions of temperature, mineralogy ...