the continuous development of global economy with decreasing in available hydrocarbon sources and increasing discovery and extraction costs due to decrease in-situ oil and gas reservoir, displays the necessity of using new techniques for the improve rate of penetration and productivity in well. nanotechnology has already contributed significantly to technological advances in the energy industri...

Solids control equipment at the rig site is used to remove rock cuttings or low-gravity solids (LGS) from drilling fluids to allow the fluid to return to the active system in a re-usable condition. Typical equipment, such as shakers and centrifuges, remove LGS particles greater than 5-7 microns. Build up of finer solids in the fluid can create problems for efficient drilling such as drillpipe s...

Designing drilling fluids for drilling in deep gas reservoirs and geothermal wells is a major challenge. Cooling drilling fluids and preparing stable mud with high thermal conductivity are of great concern. Drilling nanofluids, i.e. a low fraction of carbon nanotube (CNT) well dispersed in mud, may enhance the mixture thermal conductivity compared to the base fluids. Thus, they are potentially ...

There are essentially three main categories of drilling fluids: oil based fluids (OBF’s), synthetic based fluids (SBF’s) and water based fluids (WBF’s). OBF’s have been traditionally been used for their high performance drilling characteristics but tend to have a poor environmental performance in terms of their ecotoxicity and their tendency to persist in cuttings piles on the seafloor. More re...

The article discusses researches performed in the Well Drilling Department of the St. Petersburg Mining University. The directions of development of the department are shown. Special attention in this article is paid to research in the field of developing drilling fluids for drilling wells in various mining and geological conditions. It is shown that the gas-liquid mixtures studied by the depar...

   Drilling fluids are an essential component of the rotary drilling process used to drill for oil and gas on land and offshore environments. The injection of this nano particle into drilling fluid increases the viscosity levels fluids. In these experiments, the rheological properties of the fluid including apparent viscosity (AV), plastic viscosity (PV), yielding point (YP), mud c...

During the Integrated Ocean Drilling Program (IODP) Expedition 331 at the Iheya North hydrothermal system in the Mid-Okinawa Trough by the D/V Chikyu, we conducted microbiological contamination tests of the drilling and coring operations. The contamination from the drilling mud fluids was assessed using both perfluorocarbon tracers (PFT) and fluorescent microsphere beads. PFT infiltration was d...

designing drilling fluids for drilling in deep gas reservoirs and geothermal wells is a majorchallenge. cooling drilling fluids and preparing stable mud with high thermal conductivity are ofgreat concern. drilling nanofluids, i.e. a low fraction of carbon nanotube (cnt) well dispersed inmud, may enhance the mixture thermal conductivity compared to the base fluids. thus, they arepotentially usef...

In this study, synthetic sulfonated polymers were used in order to enhance the rheological properties of drilling fluids. The capability of these polymers in reducing the effects of environmentally friendly, but harmful, pollutants such as cement, calcium chloride, gypsum as well as pH changes were investigated. In the present work, two sulfonated synthetic polymers, namely Polythin and Polydri...

Well-drilling fluid and a number of the known components (barite, clay, Aldacide, Surflo, and Dowicide, were tested for effects on the biomass and community structure of the microbiota that colonize marine sands exposed for eight weeks to running ambient seawater. Shading the microbiota from light depressed the microflora without a significant effect on the biomass, while well-drilling fluids l...