an experimental study was carried out on the wake of a cylinder on the back of which a plate is installed parallel to the fluid flow, with different terminal angles, where the reynolds number is 50000. at the end of the plate, blades with the height of 0.25 equal to the cylinder diameter and with 45, 90 and 135 degrees angle from the horizon, are installed where the cylinder diameter is equal t...

Cf = skin friction coefficient CD = drag coefficient CDf = friction drag coefficient CDp = pressure drag coefficient h = step height M0 = freestream Mach number Patm = atmospheric pressure Pi = stagnation pressure Re = freestream Reynolds number Ti = stagnation temperature U = velocity U = normalized velocity Uτ = friction velocity X = longitudinal coordinate Z = vertical coordinate Z = normali...

Wepresentmeasurements of the dissipative turbulent drag on a vibrating grid in superfluid 4He over awide range of (low) frequencies. At high velocities, the dissipative drag is independent of frequency and is approximately the same as that measured in normal liquid 4He. We present measurements on a similar grid in superfluid 3He-B at low temperatures which shows an almost identical turbulent dr...

The aim of this study was to compare the speed fluctuation and the drag force in young swimmers between genders. Twenty-three young pubertal swimmers (12 boys and 11 girls) volunteered as subjects. Speed fluctuation was measured using a kinematical mechanical method (i.e., speedo-meter) during a maximal 25-m front crawl bout. Active drag, active drag coefficient and power needed to overcome dra...

Modelling fluid flows past a body is a general problem in science and engineering. Historical sphere drag and heat transfer data are critically examined. The appropriate drag coefficient is proposed to replace the inertia type definition proposed by Newton. It is found that the appropriate drag coefficient is a desirable dimensionless parameter to describe fluid flow physical behavior so that f...

in this study, a numerical computational fluid dynamics study is conducted in order to predict the aerodynamic forces on the np car. the turbulent air flow around the car is modeled using the realizable k-ε model. first, results are validated against those presented for the ahmed’s body. next, the fluid flow around the car is simulated for different car speeds ( to mph) and flow directions ( to...

Drag reduction of an object is the major concern in many engineering applications. Experimental studies have been carried out on circular cylinder with helical grooves in a subsonic wind tunnel. Different cases of helical grooves with different pitches, helical groove angles and number of starts of helical groove on circular cylinder are tested. Experimental results show the drag coefficient is...

in this study, changes in speed and turbulence intensity in the wake of a peugeot model and the drag coefficient changes with increases vehicle speed in unsteady flow measured and evaluated. the blow open circuit wind tunnel to simulate fluid flow is used. disturbances and nominal maximum speed of the device, respectively is, 30 m / s and 0.01%. has been continuously increasing speed by an inve...