In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...

In this paper two dimensional wave propagation is used for power combining in drain nodes of a distributed amplifier (DA). The proposed two dimensional DA uses an electrical funnel to add the currents of drain nodes. The proposed structure is modified due to gate lines considerations. Total gain improvement is achieved by engineering the characteristic impedance of gate lines and also make appr...

A novel technique for a self-equalized distributed amplifier is presented by showing the analogy between transversal filters and distributed amplifier topologies. The appropriate delay and gain coefficients of amplifier circuit are obtained by a Fourier expansion of the raised cosine spectrum in the frequency range of 0-40GHz.

[51 Bondwire inductors 0.3 3 5 * 1.2 0 . 7 2 ~ 0.32 5.1 7 4.7 c -6 4 9 3 54 Abstrncf A CMOS distributed amplifier (DA) covering 0.6 to 22 GHz is presented in this paper. Cascode gain cells and m-derived matching sections are used to enhance the gain and bandwidth performance. The DA chip achieves measured gain of 7.3 f 0.8 dB with chip area of 0.9 x 1.5 mm’ including testing pads. The amplifier...

This paper presents the analysis of the Darlington pair as an element in a distributed amplifier (DA) configuration. The Darlington pair circuit with the input and output inductor of the DA transmission line are included in the analysis of the circuit, this is also simulated. The inherent problem of poor performance is reduced by the inductors. The overall result shows that high power gain at h...

In this study an ultra-broad band, low-power, and high-gain CMOS Distributed Amplifier (CMOS-DA) utilizing a new gain-cell based on the inductively peaking cascaded structure is presented. It is created bycascading of inductively coupled common-source (CS) stage and Regulated Cascode Configuration (RGC).The proposed three-stage DA is simulated in 0.13 μm CMOS process. It achieves flat and high ...

In this paper a new method for the design of a linear phase distributed amplifier in 180nm CMOS technology is presented. The method is based on analogy between transversal filters and distributed amplifiers topologies. In the proposed method the linearity of the phase at frequency range of 0-50 GHz is obtained by using proper weighting factors for each gain stage in cascaded amplifier topology....

in this study an ultra-broad band, low-power, and high-gain cmos distributed amplifier (cmos-da) utilizing a new gain-cell based on the inductively peaking cascaded structure is presented. it is created bycascading of inductively coupled common-source (cs) stage and regulated cascode configuration (rgc).the proposed three-stage da is simulated in 0.13 μm cmos process. it achieves flat and high ...

Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...

This paper presents a four-stage CMOS distributed amplifier (DA) design implemented in standard 0.18 μm CMOS technology. The proposed design eliminates the need for transmission line capacitors and, consequently, uses significantly smaller spiral inductors compared with the previous designs. Using the minimum size inductor, the bandwidth of the amplifiers is extended, and the quality factors of...